-
Is TADO compatible with these valves?
i am looking to change my valves and would like to know if these valves (pictures attached) can be replaced by TADO TRVs?
-
Tado App stuck on orange start screen
Hi, since a couple of updates ago the app doesn’t open anymore. It gets stuck on the orange starting screen. I tried to uninstall and reinstall the app. It works the first time I reopen the app but then it get stuck again. Not sure what to do. Help!!!
-
Icos Ideal Boiler
i just moved into a house that has an Icos Ideal boiler with a seperate hot water tank. i currently have a HIVE receiver connected to the boiler , a thermostat and a HIVE hub connected to internet and power. These were all working and the owner left them but i cant use it as its not transferable. what Tado Kit do i need to…
-
Not responding
All my devices seem to be working properly. However when I try to control it through the app I see the sensor change to my desired temperature, but my receiver doesn't change the boiler. Eg I turned the heating off on my app, the sensor shower the heating was off, but my boiler was still heating my house. I gave it 15min,…
-
Installation for 2 floors
Hello good morning. I would like to ask you about the necessary configuration to cover the needs of my house. I live in a two-story house, each floor has its independent heating circuit and is controlled by a solenoid valve per floor located in the boiler room. On each floor there is a wireless thermostat receiver that is…
-
Replacing Drayton Digistat SCR
Hi I have a Drayton Digitstat SCR currently wired to my combi (Potterton Heatmax) The wiring is not the same as suggested in the Tado setup guide. Could anyone help please? Thanks, Stephen
-
Boiler not heating radiators in evenings.
The boiler heats up the radiators fine in the morning and at lunchtime, but not in the evening. Sensor says 16 degrees, so not even the 18 degrees it should be between heating boosts (heating should boost to 22 degrees in the evening). Radiators are tepid at best, so feel permanently chilly even wearing thermals.…
-
Update the app so it works properly with iPhone 14 pro camera….
….as it is there’s a focus point around arms length but it’s almost impossible to keep the resulting tiny image still enough…. I suspect a different lens or maybe macro mode needs to be selected by the app for this new phone?
-
Moved home! How to connect wireless receiver
Hi all, We just moved into a house with Tado fitted.. have managed to connect the bridge to the WiFi router, and paired the smart thermostat, but the receiver upstairs does not connect - so currently no heating!! The bridge is flashing, so is in pairing mode. The receiver has a slow (ish) blinking light on it, and when I…
-
How do I change a user name on an existing tado set up in my home?
My husband passed away recently and he was the user for tado. He added me but I can’t update the app as I don’t know his passwird
-
Tado Receiver Extension Kit
I am unable to find the differences between the following. Would someone please explain the differences and compatibility between the following please. Tado Receiver Extension Kit V3P-EK01-TC-ML-00 Tado Receiver Extension Kit V3P-EK01-TC-ML-01 Tado Receiver Extension Kit V3P-EK01-TC-ML-02 Tado Receiver Extension Kit…
-
Will THEY know?
Just returned from holiday and during last week with system in AWAY mode (Frost protection) the Lounge rads came on per HOME mode schedule. Just one rogue room! Crazy! and expensive! If I contacted tado, would their remote interrogation of my system identify the reason?
-
Two Zone heating
Hello I am a bit stuck with a setup and wonder if anyone can help please. We have a house which is divided for heating in two, main house and basement. The heating is served by one boiler with two zones, each zone controlled by a motorised valve. The main house has a basic tado installation configured for the heating only.…
-
issue with temperature control
Hi All I had enough of the tado technical support guys, very robotic and unhelpful so hoping I get better luck here! when i bought tado I got the 1x smart thermostat 3x smart radiator valves, the setup was straight forward and all worked well but the smart thermostat needed a battery change every 2 weeks, after going…
-
Worcester boiler with greenstar comfort ii rf
Hi all, I've read all related posts on the forum but still can't figure out what we need to do to set up our system. Following the tado in app install guide it simply says to remove the batteries from the old greenstar wireless controller, put batteries in Tado's controller and hey presto the thing should just connect to…
-
How to control Salus floor heating?
Hi Tado In the new part of our house we have installed under floor heating using a Salus pump shunt with manifold. Termostats / actuators can be installed on the manifold. The valve is similar to the one used on the radiators with Salus thermostats. In the old part of our house we use tado Smart Radiator Thermostats. I…
-
Tado UFH PUMP Control
Hi Tado gang, My boiler ( diesel ) is old and doesn't need any control as you just set the temperature and it is heating about 1000 litres of hot water storage and then this water is used for heating the rooms. Although two of my rooms have UFH with saswell controll box and 2 wireless sensors ( see pics below ) , 1 valve…
-
Installation without Internet
Our new house will not have internet for a few week, and I would like to setup a tado Starter Kit V3+ system with wireless smart thermostat before internet arrives, just to have a thermostat in the house to control the boiler. Is this possible?
-
Rads turning on above min temp in away mode
This year my tado is behaving differently. Min temp is set to 13 on every TRV, ambient temp is 14.6, in away mode, pre-heat is off, geo-fencing is off. Heating comes on for a few mins every morning to shoot the temp up to around 20 in each room. It comes on at the time my home schedule is supposed to start. After it’s done…
-
TRVs - Please help... very embarrassed!
I'm ashamed to say, I attempted to install some TRVs today with very little success (and some flooding). I did not realise that some TRVs were compatible and some were not. I've since learned that my TRVs are not on the compatibility list, and I've no idea what to do. I unscrewed my first TRV and tried to install the Tado…
-
Tado heating
Please can someone please help me I don't know what to do My tado thermostat was playing up saying it was 27 degrees when clearing it isn't I've touched few buttons and have no heating what so ever did it all on app and now hot water option has appeared I don't want that on there I've never had that on there before now…
-
Is Manual Control broken recently?
Hi, I have all my SRTs set to 30 minutes when manually controlled. But recently it doesn't stop after 30 minutes. About 9.20 this morning I set one to 20 manually on the SRT but it was still going until right now. Tado was reporting the room at 20.3 degrees. What is the expected behaviour if the room doesn't reach the…
-
Do I need the Smart Wired Thermostat?
Hi there I have a Tado White Smart TRV Head 4 Pack and Tado V3+ Smart Wired Heating Thermostat Starter Kit I've just fitted the TRVs and I've already got a Honeywell Thermostat, so I wasn't sure if I needed to use the Tado Wired Thermostat at all? The TRVs already have thermostats, so I was a bit confused what I'd need it…
-
Adding hot water and flow control to a Glow Worm Ultracom 18hxi
Hi, I currently have a wired v1 Thermostat (RUxxx firmware 54.20) in the hall connected to my Glow Worm Ultracom 18hxi boiler (roughly 10 years old) and a Potterton EP2 controller next to the boiler. The bridge I have is one of the original larger ones and is not recognised by the Tado Pro app so I cant seemingly use that…
-
Does anybody from Tado look at any of the questions asked? My question remains unanswered.
My Tado system has been a problem ever since it was set up by a reputable installer. Now it refuses to work. How do we go about recovering the thousands of pounds we have invested trying to make Tado work?
-
What takes priority?
If I have a room with two radiators with Tado smart radiator controls and a wireless smart thermostat, what happens with priority? If one control reaches temperature, does it overrule the others, or do they all have to read the same temperature before something happens?
-
trying to find an answer for modulation
Hi people This is my first post so go easy and im sorry if this has been asked before. I upgraded my Tado setup to opentherm, i've read all about turning down a condensing boilers flow down to save a bit. My question is, is it better now having modulation to set the flow temp to max or high temp and let tado make the…
-
IOS 15.0.1 Geofencing issues
Hi Is anyone experiencing geofencing issues on IOS 15 and above since myself and my wife upgraded our iPhones we have to open the tado app to get the location update. This always worked well before. Is this a problem tado should address?
-
Locked Out of the App - Tado Won't Update its Password
The change password routine - or the interface - on the app seems to be buggy so I made the change via a web interface but although Tado asked me if I wanted to bring the app into line it hasn't done that. Normally I would delete an app and re-install but when I attempt that with Tado I get told I will lose my data. As an…
-
How do I tell the Wireless Sensor which radiator/s to control ?
I can set a smart schedule for my Wireless Sensor - but how does it 'know' which room it is in - which radiator/s to control?