-
Radiator ignoring temperature setting
Hi all me again! I've now completed adding my smart TVs and have set schedules for each room. I have an issue however with the bathroom as it is continuing to heat above my setting of 16 deg. It is constantly heats the room to around 20 deg!. I have played with the offset and think I'm understanding this correctly. If…
-
Tado black pin
Hi all, I’m facing an issue with the Tado black pin. It doesn’t move after calibration and mounting. I have tried two smart radiator thermostat, same issue. Thanks.
-
Vaillant Ebus connection
Hi All Can tado run just on Ebus 24v or does it need 240V as well Im not sure where to connect wires to my boiler and don't want to fry the board Vaillant ecoTEC pro 28
-
Tado TRV issue!?
Hello, I’ve recently had a radiator replaced including the valves. The TRV has been mounted on the return side of the radiator and not the flow side. The valve is bi-directional. The issue I’m having is that when heat is called for, it takes a very long time for the radiator to get hot and the valve where the TRV is…
-
Are Tado trv controllers compatible?
Hi, thinking of purchasing one of these traditional style valves for a new radiator (mainly for the colour) and wondered if the trv head (wooden dial) is replaceable with a Tado? Anyone had any experience of these. Link here https://www.arroll.co.uk/products/50/uk28/antique-brass…
-
early start is starting far too early
I have my bathroom setup as a single zone; the morning part of the Smart Schedule is like this: 00:00-05:30 17ºC 05:30-07:30 17ºC 07:30-09:30 22ºC Early Start option is enabled. Away mode is set to Balance. I have noticed, that the heating is starting to heat at around 05:00 reaching 22ºC within about 40 min, i.e. it…
-
Thermostat hysteresis
Hi. I'm looking to replace my current setup - programmable timer for CH and HW (Potterton EP2002), with a wired thermostat for CH (Salus RT500). Separate HW tank (Megaflo). Boiler is an old Alpha system one (non-condensing). I'm hoping (funds allowing) to change the boiler and tank next year. I've spent ages looking at all…
-
Replacing Giacomini TRV
Have an adaptor for the above valve but there is no central bush to guide the extension pin. Is this bush normally supplied?
-
Trv not fitting on, other did I thibk
Have fitted two others on but this one won't work for some reason. I'm not 100% sure others are working either. What's best way to be sure they are turning the rads down? https://ibb.co/wrLNv9P is the image Have a veissmann 100w and opentherm via wired thermostat.
-
Tiered unit costs?
Hello, I have two tiers of unit costs. 26.14p for the first 1143kwh per quarter, 15.69p for any kWh above that per quarter. Anyone with a similar set up that have figured out a good way to put in the values into tado for estimated costs? I was either just leave it as the higher cost worst case or look back at my annual…
-
Vokera 30c
Hi I'm looking at buying the tado v3+ starter kit wireless does anyone know if this will be compatible with the vikera 30c?
-
The App shows the heating is on - but its not, What could the issue be
So as you can see I manually set the heating to come on for 20mins [disregard the time on the screenshot] the app shows that the heating is 'on' but the three 'wavy' lines next to 20.5 never lit up and the boiler didnt fire. I tried the other rooms in the house and they all worked fine with a manual selection. Im thinking…
-
Radiators don’t turn off
Hi. I have a extension a single room temp sensor and a bridge. Had it all wired in by my electrician Thursday (after having it sat on a shelf for 2 years) It was replacing another wireless thermostat. The issue I have is - I have set all the zones and temperatures. The app shows I’m calling for heat at the set time and…
-
Lk electronics
Hey I replaced the analog regulators LG regulators in 3 rooms today and it dont work. The old regulators where connected on 1, 2 and 4 and I folowed the instructions for ”Junkers” 2 for A, - for 4 and + for 1 24V. Water floor heating system It dosent work it gets to hot the regulators wont regulate. What to do. Witch…
-
Geofencing - distance from home
Hi, does anyon know if/how to set the distance from home before Tado thinks I'm away from home? I have read somewhere in here that it’s 200m but that doesn’ t work on my system. I have definitely been more than 200m away from home and ‘Away’ mode doesn’t kick in. Any help appreciated.
-
TRV Offline, no heat.
I was under the impression that if a TRV couldn't access the bridge then the temperature setting would stay as it was before the disconnection on that TRV. Am I mistaken?
-
Why does hot water come on whilst in away mode?
Been away for 5 days and checking my shell energy app which’s says I have been using the gas? On checking tado app my hot water was on in its scheduled time but it also said tado was in away mode so why is it coming on? This has now happened a good few times whilst being away but not every day? I no I don’t have the hot…
-
Energy consumption estimates
Energy consumption estimates by room do not seem to take into account if in each room there are multiple radiators or not. This is certainly the case when in a room multiple radiator valves are connected to a wireless smart thermostat, like in my living room where I have 4 radiators all connected to a wireless smart…
-
Tado not controlling upstairs radiators
Afternoon all, I've just replaced the original master unit (blue background below) with a Tado system and installed thermostats on most radiators in the house. The upstairs radiators are manual ones so I can't just put the Tado thermostats on them, my thinking was to put the wireless sensor in the main bedroom and when I…
-
Danfloss Set2e Wiring
Hi all, I am attempting to replace my Danfloss SET2E with a Tado wireless receiver. Most of the wires I can identify to the corresponding terminals in the Tado wireless receiver. I can see that I have 2 bridges (L, 2 & 5), however I am not sure what my existing 1 and 4 terminals correspond to or are equivalent to NC or NO…
-
What's the best way to setup for expected results?
I currently live in a 2 story, 105 sq m house. Using gas boiler Wolf FGB K 28 as a heating source. There are 2 manifolds, ground and top floor with 4 and 5 zones respectively. Using non-programable Uponor T-23 as room thermostats where applicable. There's no additional recirculation pump - gas boiler does all the work.…
-
CABLE EXTENDER ETHERNET CABLE
I need to move the internet bridge and my router so need a longer cable. What is the correct name of the small end that plugs into the power supply plug as I can only find usb or double ended ethernet plugs? Thank you
-
Balancing, is it needed with TADO.
What’s the definitive answer? do we need to balance radiators if you have TADO TRV’s or do TADO TRV’s do the equivalent by throttling the passage of hot water as it opens and closes? for context I have 2 floors, 10 rads with tado valves and valiant ecotec 630 unvented with vsmart, TADO only does the trv’s not the boiler.…
-
Removing broken stat
Smart thermostat RU3583912448 was faulty and temp stuck. I replaced it with RU1218128384 I have tried to remove the old one from the system. But just reads. The response from the server was unexpected. Please retry TadoKit TadoCloudError2.
-
Two zones system
I have two zones in my heating system one is underfloor water heating and the other is radiators. I have two wired Tado controllers for the underfloor heating and a wired controller for the radiators. Before installing I asked for advice from Tado to ensure I got the right equipment. Now my system does not work…
-
Replace Hive
Hi. We’ve just had a new boiler fitted by British Gas and had to have a Hive wireless thermostat fitted with it. I have Tado thermostats on all our radiators and, obviously, the two systems are incompatible. I would like to know what I would need to replace it with a Tado wireless thermostat. The Hive consists of a wired…
-
Wiring Question: Replacing Wired Control+Thermostat with Tado Wireless v3+
Hello, I am replacing a wired control + wired thermostat with Tado wireless v3+ starter kit. Details of the current devices: Boiler: Glowworm Energy 30c Control: Drayton Lifestyle LP811 - to be replaced with the Tado receiver Thermostat: Satchwell TLX 2259 - To be replaced with the Tado wireless temperature sensor I…
-
May buy Tado, would like more info. on Vaillant Ebus integratioin if possible.
Hello, I'm a Gas safe engineer myself and I'm considering Tado in my own home but also to possibly start fitting it for customers. Regarding my own home - I have read some other posts but my specific questions don't seem to have been covered. I have a two year old Vaillant Ecotec Plus 418 Open Vented (not a system) boiler…
-
Does tado work with boiler's external temperature sensor?
I am using WOLF FGB-K-28, which has optional outside temperature sensor and it helps adjust the flow temperature automatically, instead of manually as I do now. I guess it might be quite obvious, but may or will tado interfere with this in any way or it shouldn't really? Thanks in advance!
-
End of windows 10 support
as the email you sent regarding the latest app update. "if it is a Windows computer or a Windows phone, they cannot be updated to the latest tado° app version" It is a major advantage to me that the system can be set using a decent sized screen / pc. I guess for those with perfect eyesight a tiny mobile screen is fine but…