I'm just curious, if anything happens to my bridge, e.g. my cat chews through the wires, can I still control my heating (temperature, on/off) using the wired Tado thermostat?
Hi, I am sure this has been discussed many times, I have read numerous threads but I cannot see any with my specific setup... I have a 3 zone plus hot water system, currently time managed by a Timegua…
We have an existing Tado installation with most (but not all) rooms having Smart Radiator thermostats & Smart thermostats. Currently, all of the smart thermostats can call for heat. I’m thinking of mo…
Hi, The buttons on my thermostat aren't responding to touch even though the battery is showing as good and the blink test works? Please advise. Kind regards
Hi All, Last night for the first time ever, the heading was stuck on and could not be turned off from my phone or thermostat. The Power Led on the wireless receiver was flashing orange, and the LED in…
I've installed the wireless receiver as per instructions. The system used to have another thermostat system so these were the only wires I could change over. It all looks correct to me, but the boiler…
Help! Installing Tado V3 today. HW works fine but I am unable to find instruction on bypassing my old wireless CH thermostat receiver to enable TADO control of the boiler for CH. Receiver is a Plumb C…
I recently deleted my whole account (unintentionally) and had to create a new one and add all my devices back, however my hot water appears to not be showing in the app Home Screen and I don’t know ho…
Awaiting electrician to connect Tado programmer, done Internet Bridge satisfactorily but the Tado TRV says offline Should it work while programmer still not connected please?
As the tado trv in my lounge is pretty much covered with furnitures, I have put an additional thermostat more in the middle of the room. Not quite sure how it works though. Did not pair the 2nd one wi…
Do I need a subscription for geofencing to automatically work when both our phones are away from home? It shows both our phones are outside the perimeter but the temperature indoors stays set to home
Hi We have a tado V3+ that it not working, about twice a week, although the app shows the heating should be on (always in a morning) it's not coming on, it only works when I select the boost option. A…
Hi all, Tado user since 2017 where have the following setup... EPH 3x channel/zone programmable control panel (2x CH & 1x HW) with a wired thermostat for downstairs and a wired thermostat for upstarts…
Hi I have a few thermostats in my house that I am planning to replace with Tado Wireless. 1) What is the max distance between Smarthub and the thermostats? 2) I will have 4 thermostats (wired) connect…
Hi Everyone, So we have a new build property with an Ideal boiler which is capable of Opentherm and modulation. I purchased the Wired version of Tado as I read that it was capable of achieving this vi…
Hi have just had new wireless v3+ installed, the bridge and controller are online but the wireless thermostat is off line, have tried pairing loads off times have reset, have moved the bridge but can’…
App says to contact support so going down this route. Any help on the wiring for swapping these over? This controls the hot water and there are two wired thermostats for 2 zones that I need to replace
So got a new Tado system installed yesterday. Not impressed. 1x wall mounted smart thermostat (upstairs zone) - replaced old danfoss thermostat 1x wall mounted wireless temperature sensor (downstairs …
I bought and installed Tado Starter Kit with Wireless Smart Thermostat to replace Danfoss TPOne-M controller for main central heating and hot water. That works fine but I also bought and installed a T…
Issue The Tado was causing the boiler to enter Anti-Cycling mode. After speaking to Tado tech support, they have changed the Tado relay “to turn on once there is a heat request, and turn off once this…
I have underfloor heating downstairs and radiators upstairs. I also have a hot water storage tank upstairs. The timings associated with the firing of the boiler are managed by a three channel controll…
Hello, we need your help to see if/how I can control an underfloor heating with our current Tado system. Situation We have a conventional boiler and a hot water tank. We have a wireless receive/extens…
I've searched for this, but no one seems to have the same problem. I have a schedule set to turn my AC to heat every morning, and turn off at 7:30. However, most mornings the tado unit doesn't send th…
Hi All. I have an Ideal Logic+ 35 combo boiler and I've just installed the Wired Smart Thermostat starter kit v3+. I specifically chose this as both the boiler and the smart thermostat both support Op…
Hi Everyone, So thanks to you lovely people, I managed to realised the Wired Thermostat was not infact suitable for my use case and therefore ended up purchasing the EU version to allow Opentherm and …
