-
OpenTherm with no hot water control
Hello, I am sorry if this has been answered somewhere, I couldn't find it. Here is my problem: I have a Brotje WHBS 22D boiler with Tado wireless receiver connected through OpenTherm and controlled by a Tado wireless thermostat (plus 3 more TRVs in the same zone). The heating is working just fine but I can't seem to be…
-
Wallplate for wall-mounted radiator valve
Hello all. I am migrating all of my radiator valves to Tado smart radiator valves. And I've run into a minor issue. I have a radiator installed in the floor with a vent to heat my dining room area. The radiator valve for this heating is installed in the wall. And there is a wallplate (similar to what you would use for a…
-
Part Number for Smart Radiator Thermostat Quattro Pack
Hi all, Support from tado chat is diabolical. Would someone be able to confirm what the six digit Part Number / Model number is for the *most recent version* of the 'Smart Radiator Thermostat Quattro Pack'? Amazon is saying Part Number 104043 has been superseded: "There is a newer model of this item available". There is…
-
Wires installation troubles
Hi, Been trying to set up my tado but the wires are a mess due to the previous system that was installed since before we moved in. I have a black, grey, brown cables coming from the heater, and red, blacl from the plug that used to turn the system on/off. The black,grey are tied to red and yellow cables that seem to go in…
-
Heating
Cannot stop our heating coming on with the water, only way to stop it is to switch off water
-
Can you download Tado App onto multiple phones/devices?
House holds will have 2 or more phones. Is system compatible with multiple device installs, eg phone and ipad or 2 phones?
-
Reverting to Smart Schedule
Is it possible to use the Tado wall mounted unit to revert back to Smart Schedule? So i have a schedule programmed, decide to increase the temp manually on the wall unit but then, later, want to revert back to Smart Schedule, ideally using the wall unit again, rather than having to find my mobile and revert to schedule on…
-
Which tado starter kit should I get for my case (Wired or Wireless)
Hi, I'm planning to get tado smart thermostat and TRVs for my apartment. I'm quite new to this, did some readings. I have some questions and would appreciate advice as well. I live in the Netherlands and have intergas hre 24/18 boiler with water tank, boiler is wired honeywell modulation thermostat in living room. Since I…
-
Controlling an air heat source pump and oil heat source on the same system
Can you advise if Tado can control two heat sources. In the USA Air to Water heat source pumps are used in conjunction with additional heat sources (often oil) that are used as system back-ups when the first system is not sufficient. Can you advise if Tado is capable of controlling the two heat sources in one system?
-
Integrate or replace old Heatmiser UFH system
Hi all, I just asked this in the technical section, but have sen that maybe this is the most appropriate place. Forgive me if not. I have two circuits on my heating system. An old Heatmiser system that controls the under floor heating on the ground floor (8 zone with a UH1…
-
Mounting smart temperature sensor
Hi. Temperature sensors keep falling off the wall when using the sticky pads provided. A friend recommended gorilla tape or squares. Anybody used them? Or perhaps buying a stand is better? Thought please 🙂.
-
Connecting Tado to Danfoss Wireless underfloor heat system
Hi I have a 23 years old Danfoss wireless underfloor heat system. It is still well functioning, but due to the energy crisis we have at the moment, I'm looking for something smarter, and here I am.... My question is: Is it possible to combine the Danfoss CFM-230 Master control unit with Tado wireless reciever? If not - How…
-
Temperature switch on
Hi is there a way the change at what change in temperature the heating switches back on whilst using schedules. Currently it’s seems the switch the boiler back on at .2 below the set temperature. I would prefer it to not switch on until -2 below the set. Thanks
-
How can I disable Geofencing when in my garden office?
I have geofencing enabled, which works brilliantly. During the day I work in my Garden office, so I want the heating off. My work schedule isn't consistent enough that I can simply schedule the heating off during the day, sometimes I work in the house, sometimes I'm elsewhere. My garden isn't large enough to be able to use…
-
Auto-Assist
Ciao a tutti, mi interessava capire se ha senso attivare l'auto assist avendo riscaldamento centralizzato...se e quali funzionalità avrebbero utilità Grazie
-
Heating not responding to Tado, remains permanently on.
We have a Valiant EcoFit pure 425 installed in 2018. I installed a Tado Smart Thermostat, extension kit and internet bridge. It’s always worked without a hitch until we turned the heating back on last week, now the heating doesn’t respond to the smart schedule or manual intervention via the app, it stays on permanently…
-
TRV Not connecting Radiator constantly on very hot
I have been using Tado for 3 years and have 11 rads All normally works fine I changed the batteries in a TRV after receiving warning it was low. Since then it says there is no connection. I have taken the batteries in and out and switched internet router on and off to no avail Tried several times. I have tried turning the…
-
Android app 6.68.0
Anyone else getting the temp data has disappeared from the left side in the graph in the app? Also I manually set the temp to 21.5°c and it keeps heating on past 22.2°c. it doesn't seem to turn off!
-
Switch from hive to tado wiring question
Hello, I just moved to a new house and it has hive receiver (dual channel) wired to a conventional boiler (ideal icos he24) but no thermostat left :( From Hive installation guide: I would like to take this chance to switch it to tado. For the wiring, should I follow the below diagram? Blue --> N Brown --> L Black --> HW NC…
-
Could the Taco Bridge cause interference with other RF devices?
Hello, I have just installed Tado devices in my whole house, 15 thermostatic valves, total. For the first couple of days, everything seemed to work alright except for one of the valves that I couldn't register to the bridge. I have found a way to position the bridge vertically instead of horizontally, and I then could…
-
How to turn on hot water from extension kit without internet
Hi, I have a thermostat and extension kit that is linked via an internet bridge. Extension kit is connected to control wiring to heat hot water for the hot water storage cylinder. Frustratingly, they are on a building site, so there is no phone line or internet available on Ethernet and the bridge does not work with wifi…
-
Thermostat
I had todo installed 6 years ago and the thermostat replaced a wired Honeywell. In the room where the thermostat is located we now have a log burner so thermostat thinks whole house is warm. Can I replace the wired taco thermostat with a taco wireless thermostat so I can move it around the home and if yes what do I need…
-
Managing hot water with Combi on Opentherm - Using energy?
In order for the hot water temperature to be configurable whilst my boiler is in opentherm mode, it requires that I manage that through Tado. So I have the hot water icon in Tado now and can adjust the temperature. But given it is a combi, is there any issue with the hot water schedule in Tado showing as enabled 24/7 - I…
-
Can I place Tado Sensor into sauna?
I want to see electric sauna temperature remotely. I do not want controls, just the temperature. I was not able to find the maximum temperature for Tado device. Also is it moisture resistant? P.S. Harvia saunas has remote control option with temperature sensor but the module itself cost same as heater…
-
Just 2 smart rad valves and Tado smart stat?
Looks like Tado is answer to age old battle between rad settings on kitchen, hall and living room. Obviously these do not all need to be in comfy temperature zone during normal 7am -10pm day! I propose Tado smart rad valves in kitchen and living room. Standard existing TRV on hall rad with Tado smart thermostat in hall and…
-
smart schedule being overridden
hey all just a quick question, does anyone know why the smart schedule doesn't work or change when the thermostat is controlled manually. it used to change at the next time block automatically. yes i know everything can be controlled from the app but my wife does not use the app, she always turns it by hand hence the…
-
Wireless receiver, UFH complete failures
I've had tado for a number of years, we've just recently put UFH in. Unfortunately, during the renovation we lost the backing plate of the old extension kit. So replaced it with a wireless extension kit... Not so wireless... I've had an issue with the boiler cycling because the heat output required is far less than the UFH…
-
Can Tado do this ?
I have a Ideal Logic boiler with a hot water cylinder attached to it (Kingspan). This has 2 (very bad) wired thermostats attached to it (one for the house in the hallway and one for the master bedroom). We have a 4 bedroom house and I would like to be able to control the temperature in the other bedrooms independently from…
-
Wired Thermostat and 3 Smart Radiator Valves not working correctly
I have had a Tado wired thermostat for some time. It's located in the hall where there are no radiators. I have just purchased 3 tado valves for use in the three rooms we use the most but not all day. I have set the office temp higher in the daytime and the living room higher in the evening and the bedroom to come on for a…
-
How can I link a smart trv and wireless thermostat ?
Hi, just had a new system fitted, we have three underfloor heating wired thermostats downstairs, along with 4 radiator smart TRV'S. On the first floor a wired thermostat and the rooms then have a smart TRV on each radiator and currently in 3 of the rooms wireless thermostats. on the 2nd floor two smart TRV'S. In total…