-
Bridge does not connect (SALT Internet Service Provider ISP)
Dear all, I am opening up a new thread since I tried all options from thread "Installation & beginner Idiot proof answers if possible", which - if you ask me - deserves a sticky also in the German forum. Anyways, it helped me so far to figure out that it is not a hardware problem of the bridge and the problem lays with my…
-
Re: Verschil in versie radiatorknop
-
how to instruct Alexa to tell TADO to Resume Schedule for all thermostats (6)
I have setup 6 thermostats in the house with schedules, BUT when I tell ALEXA to increase the heating in one or two rooms, TADO does not "Resume Schedule" until I use the app to do it!. Can anyone tell me how to set up a routine in ALEXA to do this?
-
Determine remotely if heating is on
Hi guys, I have a wireless tado starter kit that I have just installed. I want it to control heating remotely (mostly). I installed it today for the first time and I notice that occasionally when I change the temperature on the thermostat it doesn't change on the app. Maybe 30 minutes later then it does get the new temp…
-
Heating seems to come on once a day for a few minutes?
Hi all, New Tado user here using the system with a combi-gas boiler. Since installing the system I've noticed the boiler fire up for 5 mins or so at around the same time each day. I have all thermostats and TRVs set to Off ("Frost protection"). Any idea why this might be happening? Seems very wasteful, especially as spring…
-
Beep
Hi. Anyone heard their Tado thermostat beep/ping? This happened twice today. No idea what this means!
-
Radiator valve angles
I have a couple of radiators in my home with TRVs that are at a 45 degree angle - so neither horizontal nor vertical. The Tado smart TRVs on these both have a spanner icon displaying but no other error code so was wondering if the 45 degree angle could be the problem. Has anyone had similar issues or know if Tado's smart…
-
No Water Heating Icon on Tado App
I do not have Water Heating icon on App, so can't programm water heating? Extension kit is installed, heating is working, but no way to set water heating?
-
aura
can the wired thermostat replace a aura JGSTAT2W for underfloor heating?
-
Cuando abro el agua caliente se enciende la calefacción.
Tengo una saunier Duval isofast F 30 E H-MOD. He comprobado que cuando abro el agua caliente, al poco tiempo empieza a perder temperatura el agua sanitaria. Y comienzan a calentarse los radiadores. Pensaba que podía ser una avería de la válvula de 3 vías. Pero si quito Tado y dejó el mando de la caldera funciona…
-
Failed smart thermostat
Is there a contact to replace the smart thermostat. I have bought a kit with eight and one doesn't even light up when I put batteries in. I've looked everywhere, can anyone help ?? I've tried new duracell batteries etc, it's dead, never even lit up once. Thanks.
-
Away Mode - Has something changed?
Just back from holiday and as per previous practice over the years just manually shifted to Away Mode on departure only to find on return that the Lounge has run per schedule the whole week. No other room just that one. Two large rads controlled by wireless stat - what a waste! Any ideas please?
-
Worcester Bosch Greenstar 30si - No Power to Tado
Hi all, Have wired up my V3+ extension kit to the boiler following the instructions within the app for the Worcester Bosch Greenstar 30si, wiring into Ns Ls LR terminal block as per attached but on switching mains power back on, the extension kit doesn’t seem to be receiving any power at all. Boiler operating fine as usual…
-
Heating doesn’t start until I don’t open the app
Since a couple of months, I have noticed that although there s a routine in place the heating doesn’t start until I don’t open the app. I’m an iOS user and I haven’t changed anything in the app. Any suggestions?
-
Anyone got a fix for issue with Tado resuming schedule at midnight GMT (1AM BST)
I've been trying to save money by having Tado turn my TRVs off (or at least frost protection) which it does initially but resumes schedule on all rooms at midnight GMT (I first noticed it happening before daylight savings and now it happens at 1am). Have confirmed all rooms are set to only resume when manually instructed…
-
Adding Tado for wet underfloor
We currently have Tado set-up for our central heating (radiators) and hot water and working fine. This comprises a Tado wireless thermostat with Tado extension kit/programmer. We have one additional room that is wet underfloor, and trying to connect this room up to Tado as well. Our plumber replaced the Honeywell wireless…
-
im not sure
hi. all i have a wired starter kit. and have managed to set up the wifi bridge with the thermostat im stuck on this bit. when i removed my old thermostat it had 2 wires. i tested these with a meter and it was 240v. so mains? if i join these to wires together the boiler fires up. so it must need a relay in the tado so my…
-
Tado thermostat
My thermostat is getting worse, I have set programmes for when to turn on and off. It seems to do whatever it likes. Boiling through night freezing in mornings, I'm sick of it, would prefer a manual dial.
-
Balancing thermostats
Hi, my house is 3 storey with tado thermostat on 1st floor landing next to radiator with no TRV. I've added tado thermostat on ground floor where it is colder and of course that is usually calling for heat when 1st floor is already warm enough. Should I look to move "fixed" non TRV valve to ground floor at some point or…
-
Why no remote access for a room with two apparently connected radiator stats?
Both rad stats show up on the app as connected with good battery levels. The room they are in is connected to the same zone controller as all other rooms, which are fine.
-
Hot water stopped working
I installed 3 smart radiator thermostats. Now my hot water won’t come on, from either schedule or manual override. The radiators work fine. Any ideas?
-
Thermostat stopped working after turning off water stopcock
Hi, I've got a tado Wireless heating & hot water kit with 6 tado radiator valves. Everything was working perfectly until this weekend. On Friday I was doing some painting so removed a radiator from the wall in one room to paint behind it - this radiator had a standard non-Tado thermostatic valve. To remove it from the wall…
-
IQ readings
I’m confused. I’ve just started doing monthly reading and adding the data. Do I just add the data month by month or do I add 1st month onto the 2nd month and so on. I have not been been doing that just adding each month but I have just added my latest reading and it won’t let me And says. The current reading can't be less…
-
Worcester greenstar 34cdi wiring
Hi, I’ve purchased a kit and looked through a few guides and videos on how to wire to the boiler, I’ve seen a user (thread below) not wire into the Ns Ls ports on the boiler, but the instructions from Tado and Worcester advise to connect to these and not the bb. I’m not sure about the switch bridge where this goes on my…
-
Tado thermostat faulty
Brand new thermostat, faulty contacts, permanently output is on, not great. Sent message to tado, require replacement urgently, esp with having small baby in house.checked batteries all measure 1.56v everything synced ok, output on always, tapped the stat contacts opened but when called for heat output stayed on evem when…
-
Hot water constantly on?
We had Tado installed with our new boiler last week. All seems fine with the heating but the boiler was firing up at random times when nothing was calling for it to do so. We think we have realised that the hot water is constantly on so when we use the hot water, this then ignites the boiler. This is despite the app saying…
-
Mobile phone notification
Hi, is there a possibility of notification when the temperature changes manually on the thermostat itself? Not via Tado app but on the thermostat itself. Or if it can be set that when the temperature is changed manually so that the time is not infinite but the last set before returning to the schedule? Best regards
-
Heating motorised valve staying open while call for water but no call for heat
I've had a tado extension kit fitted onto an s-plan system. I have an issue where this sequence happens: call for hot water in the app hot water motorised valve opens call for heat in the app heating motorised valve opens cancel the call for heat in the app heating motorised valve will not close. cancle call for hot water…
-
Adding an Extension Kit/Wireless Receiver to existing system
After any thoughts on what I need to do here, as it hasn't worked as I was expecting (hoping!)... I have been stuck with a 3-channel boiler programmer that i could not replace as tado don't support 3-channels programmers. Therefore I have never been able to control the hot water via tado. Upstairs I have a smart thermostat…
-
The most important feature
I have 12 TRV's and two of them are disconnecting on a regular basis. Use of power line devices its not really a work around as is moving my whole internet connection setup. My question therefore, given the issue has been around since 2017 and other competitors have a solution, is this most important feature at the moment…