Tado Smart Radiator Thermostat and Heatmiser Thermostat

aekash

In my home on the first floor passage I have a Heatmiser Thermostat which controls the heating in all bedrooms on the first floor.

If I were to fit Tado Smart Radiator Thermostat's on all the radiators is it possible to control when the actual boiler turns on by replacing the existing Heatmiser Thermostat with a wired Tado smart Thermostat ?

• Can the same Heatmiser Thermostat wiring be used i.e. simple case of just removing the existing Heatmiser Thermostat and replacing it with the Tado smart Thermostat ?
• Can individual Tado Smart Radiator Thermostat's send a signal to a Tado smart Thermostat to turn on the heating (if I am able to replace my Heatmiser Thermostat with a Tado smart Thermostat as mentioned above)

Any help will be greatly appreciated

Thanks

Aekash

JonDavy

Hi, I have the same question, did you work this out?
Sorry I can’t help you
Jon

Ebstar

I'm not sure of your exact setup but I have one that sounds similar - new build property - UFH downstairs and a single Heatmiser Neo in the hallway upstairs controlling the rad's in all the bedrooms.

I have put Tado TRV's on each radiator and am about to replace the wired Heatmiser Neo stat with the Tado Wired Stat..

I think it will work fine and I have seen a similar setup mentioned on Reddit here https://www.reddit.com/r/tado/comments/m7404n/using_tado_for_radiators_and_heatmiser_for_ufh/

Cheers