-
Vaillant Ecotec at only 20% power - it's cold!
I have recently bought and installed a Tado V3+ starter pack and two additional Smart Radiator Thermostats. I have 4 rooms configured, with the main one our living room that has the wall-mounted Smart Thermostat and 3 smart radiator thermostats. The boiler is a Vaillant Ecotec Plus from 2014, type VHR NL 25-30 (previously…
-
Is V3+ backwards compatible?
I currently have the V1 set up, purchased about 10 years ago. Still working, but time for an upgrade as it’s now showing its limitations. I’m going to put in the V3+ and ideally, will add one or more additional temp sensors, so that the system can be programmed to read different locations at different times, to reflect our…
-
No hot water Remeha boiler
Hello! I've been using tado conntected with my Remeha boiler about 3-4 months and very happy with it. I've installed Tado myself. Then the problem starts.. Occasionally there's no hot water when I want to take a shower. The boiler shows an error message. On the app, the hot water is on. I have to turn the boiler off and on…
-
Please help! I can only have heating if the hot water is on?
I want the heating on but I have to have the water on at the same time? When the water reaches temperature the heating goes off. The heating temperature keeps rising until the water turns off. This is costing me a fortune and the house is wither red hot because the water has been on or its freezing because the water has…
-
Two zone heating not working
Hi folks, I have just bought and set up the following: - wired smart thermostat (downstairs) - wired smart thermostat (upstairs) - wireless receiver (replaced a dual zone control panel and not linked directly to boiler - 3 x smart thermostats (2x upstairs and 1x downstairs) I have set these all up DIY following the…
-
Two (2) different Boilers
Hi Can I control 2 different boilers (1 dital, 1 relay) with 2 different wireless receivers and 1 internet bridge and 1 user account? Cheers Heursqem
-
Change wireless to wired sensor and get Opentherm function?
Hi Folks, I bought the wireless TADO version a year ago and it's been working fine with my Vaillant combi boiler. https://www.screwfix.com/p/tado-v3-wireless-heating-hot-water-smart-thermostat-starter-kit/141kt If I replace the wireless temperature sensor with this black wired one below, does that get me Opentherm?…
-
Radiotorknob dont starting after dead battery's
Hi All! after a weekend abroad i came home finding my tado radiator knob out of power. when change the battery's it isent given any signs of life. i did check them on another knob en they work fine on that one. any sugesstions? i did try a full reset.. let me know !
-
Switching from Hive to Tado…help confirming my options please
Hi, I currently have a Worcester Bosch greenstar 42CDI combi, on 2 zones (upstairs and downstairs) with Hive thermostats on each zone, 14 radiators in total. We did have hive TRVs on each radiator but they were awful…Hive were adamant they were working perfectly, but they’d be on when the app said they weren’t, they…
-
Trv issue
Guys new'ish here, I'm having issues I got this system in Sept. 1 of my TRVs was playing up and needed new batteries but since it has been all over the place. If I change temp or after geofence the TRV changes the degrees on it and then display disappears but no movement of the motor, (it does sometimes) I have swapped…
-
How to change wires from Siemens RDE10 to Tado?
Hi! I am really new to the whole cabling world, but after being quotes £150 for installation I thought I could definitely try to learn something and I think I made some progress, but still need help. I want to replace my Siemens RDE10 connected to a heat exchanger (note - not a boiler) with Tado. I currently have blue…
-
Where do I buy the Tado wireless for my boiler?
I’ve bought the wrong starter kit. I have the bridge, the rad valves plus I bought the thermostat. Trying to buy on the Tado ( UK) site gives me an error 404!
-
Heating not responding, staying on all the time
Hello all, I need a little help. I installed the Tado wireless starter kit on my s-plan heating system. There are no smart TRVs on any of my radiators, I decided to add those later. At the moment I’m just trying to see if the heating and hot water turn on and off as they should. This is where the problem is. The heating…
-
Termostato no corta la calefacción
Hola! Tengo una caldera Roca Novanox 28/28 F, en una vivienda con 3 plantas con termostatos Roca RD200 en cada una de ellas. He comprado 3 kits de Termostato cableado V3, uno para cada planta (era más barato que sin el bridge). He instalado el bridge y el de la primera planta y todo perfecto. Al instalar el de la segunda…
-
Tado WiFi usage
Hi all does anyone now if Tado is data hungry at all. My wifi has been intermitantly slow from around the time I installed Tado. Sky have told me my data usage in the last two weeks has risen from 295 g to over 1000g! I'm desperate to find out what is causing the massive increase
-
Tado Radiator Smart thermostat - 'mounting Issue'
Hi All. I have the following issue with one of my radiator thermostats and im looking to nip this problem in the bud. So, this particular tado rad thermostat has been working flawlessly up until about a few months ago. The dreaded red dot appeared on the app so investigated further and it says the device is not mounted…
-
does the smart thermostat works with this setup?
Hi i got this setup in my house, can i install the smart thermostat from tado? My current boiler is a NIBE F730 with the room sensor NIBE RTS 40
-
5 Radiators in 2 bed flat
Hi, I live in a split-level maisonette with 5 radiators, 1 in each of the 2 bedrooms, 1 in the bathroom and 2 in the living room. I have the smart thermostat connected to the boiler and that has been working very well for years. I now want to add smart TRV. I have purchased 2 for the bedrooms and I'm waiting for them to…
-
Existing underfloor heating thermostats cannot call for hot water from boiler!
I have 4 thermostats in my home. 1 in the main living area upstairs connected to an underfloor heating manifold and 3 dial thermostats in individual rooms downstairs connected to a separate underfloor heating manifold. The the main area thermostat controls the upstairs underfloor heating flow, and the three room…
-
Not strictly a Tado question…
…more of a boiler question. I have range rated my boiler(Worcester 38cdi classic)down to its minimum power output of 9.4kw. How is it then that I often see spot readings of well below 9.4kw on my smart meter monitor, eg: 2.445kw as shown below. I have my extension kit connected to the ems bus connections in the boiler, but…
-
Contact number for Tado?
Is there a contact number for Tado? Also the response from chat is only bot and is the response to Tado is only via email for any issues/warranty/faults?
-
Ideal Evomax 2
Hi Just had a new boiler installed, Ideal 60kw evomax 2. It does the heating only, hot water is entirely separate We don’t have any thermostats yet, basically the heating is a dumb system, on/off timer - does anyone know if the Evomax 2 will work with a Tado system plus any advice on being wired vs wireless? Many thanks
-
Installed New Boiler and Tado smart thermostat V3 : The App shows the heating is on - but its not
Recently I installed a new boiler in my home along with tado smart thermostat. I have installed a Tado Smart Thermostat V3 in my home and also installed a new boiler in my home (Vaillant ecoFIT pro VUW 356/6-3 ) and it is connected to tado wireless controller. The controller shows the temperature but the radiators are not…
-
Will tado Internet bridge work with ZTEMF293N mobile broadband with O2 Sim
Hi guys I have recently lost the use of my BT hub and broadband so I purchase I said to you ZTE 293N mobile broadband router powered by O2 SIM card with excellent signal Has one ethernet port which is enabled , as I access the router via a Mac to set it up i’ve tried to connect the Internet bridge to it via the ethernet…
-
Junkers Euroline ZS 23-1 compatibility
Hello, I have Junkers Euroline gas boiler and Siemens RDE 10.1 termostat. I wonder if I can replace it with tado wired thermostat. Thanks!
-
TRV extension spindles
I have existing TRVs that require extension spindles to be fitted but I can't see any means of keeping these co-axial with the valve. A simple bush is all that is required but are not in the adaptor kit. Anyone?
-
Error Lights on Smart Thermostat (wireless)
Anyone seen this set of error lights (they are dots incidentally!) Wireless unit being a complete trumpet - Can still set temperature on the device via app etc so it's in communication - but the sensed temperate is 'stuck' Google hasnt helped sadly
-
Can someone help me understand what products i need?
Currently I Have 2 zones controlled by wired wall stats and a central control panel that programs times and hot water etc... My boiler and Cylinder currently take orders from the control panel, the stats sending back to turn "on" (during a heating on period) the heating for the zone it controls when the temp drops below…
-
Remeha avanta
What is config. Menu ID for Remeha Avanta 28s
-
Bizarre v3+ installation experience
Having run a v1 (beta) system for the last 10 years, I decided it was probably time to upgrade, so picked up the cheapo black v3+ in the sales. Reluctant to commit to installing it (for fear of having to contact the mythical tech support), I'd sat on it for a couple of weeks, but decided to go for it this morning. Really…