-
Fritzbox 7490 - cloud light blinking
I access my home Internet connection with a fritzbox 7490. When trying to connect the Internet bridge for the first time, the power and router lights stay lit up and fixed, but the cloud light is always blinking. I have been unable to find a solution to the problem and am unable to connect the Internet bridge. Which…
-
tado 3v Does it not support Mitsubishi air conditioners?
Just replaced the Mitsubishi air conditioner, Identifying your AC model , We couldn't identify your AC model Signal detected Could not identify AC
-
Can I control 3 boilers with tado?
I have three boilers that heat different parts of the property. Ideally I'd like to use one wireless kit plus two wired thermostats but if that isn't possible then I can run cable so that all three are controlled with wired thermostats. Will this work?
-
UK Modulating Boilers with Tado
Hello I'm in the UK. My boiler has reached the end of its life and needs replacement. The replacement will almost certainly be heat only, working with a hot water cylinder. I am quite invested in Tado, with a v2 extension kit, wireless thermostat and lots of smart radiator valves. I'd quite like to get a boiler which will…
-
Hot Water not firing up boiler?
TL DR; Hot water won't come on even though no errors seem to be present in either app or wireless receiver. Hi there, This is a long shot as I know very little about plumbing in general but gave it a go as all the instructions were relatively straight forward, but before seeking professional advice, I wanted to ask here.…
-
Temperature WAY off
Hi, I have a Tado smart thermostat first generation. It has a remote temperature sensor, placed in a central position of the house, far from any radiator. this setup has worked well for several years and nothing changed. Lately, it's showing a temperature which is WAY off... I see a temperature of 34.2 °C while in the…
-
Myson 24v
Hi all, Can someone point me in the right direction… Our underfloor heating controllers are analog and 24v but can’t find the right wiring setup for them These are the thermostats we currently have: https://www.mytub.co.uk/myson-24v-room-thermostat-50507-product-108386 Thanks in advance
-
Energyiq now predicting a £0 gas bill for October
It had been predicting a £47 bill now it has dropped to £0. The tariff is set correctly, at £0.10 kWh at 400 kWh I would expect a £40 bill but EnergyIQ is estimating a £0. While very excited to see the charge drop, I am sceptical of its accuracy. I am new to Tado, is it really this flakey?
-
Ideal vogue c32 gen 2 tado installation
Advice needed! This is the current wiring in our boiler. The white wire is the mains cable and the black is the Condensate Pump.according to instructions I need to connect to L, N & room stat. The L & N already have 2 wires wired in, room stat has 1 in each terminal from the condensate pump. Where do I go from here?!
-
2 apartments in one account?
Hi, I have 2 apartments heated by the same heater. Tado scheme D, but each apartment has its own wi-fi. If I connect new internet bridge at the rental apartment, everything tries to connect to this new bridge. Is there any way how to do it? I think about inconvenient option to have the rental apartment on different account…
-
Anyone else find the new app changes annoying?
Just updated the app on my Samsung phone and noticed that I now can't easily change a room/HW to a manual period e.g. it used to be possible to tap on the HW button and the app would then change to manual mode and you could edit the time required for the HW to stay in that state. Now you have to change the state OFF -> ON…
-
I have Underfloor heating (3 Zone ) and radiators.
I have installed 2 x wired Thermostats where the Underfloor is in the Living room and and Separate Wired Thermostats in the other Zones in the House , But it will only heat either the Rads on there own or Underfloor on there own . Can anyone please help as to how i can make this happen. They are separate on the oil Burner…
-
Why is the boiler suddenly pumping out heat 3 or 4 degrees above the set temperature?
My basic system is about 6 years old and is only for the heating. Just switched the boiler on for the winter season, but the boiler is heating way above the target temperature. Simple wall mounted thermostat. Installed by D&G and always worked well to date. Thanks for any advice
-
Don't know if change the thermostat can help.
My home is using a conventional boiler which provide central heating as well as connecting to a water tank for hot water. A honeywell programmer is next to the water tank cupboard, then the wireless receiver. The Honeywell wireless thermostat is in the lounge. The bathroom have a towel rail (full flow without TRV, and all…
-
Install Issues
Hi, New user here. ive set up and installed the below and wondering and hoping someone can guide me in the correct path. i have 3 Zones in my House which control oil-based heating system. Zone 1 Downstairs Rads Zone 2 Upstairs Rads Zone 3 Downstairs Living /Dining & Kitchen Area underfloor Heating (Water Based) i recently…
-
I cant get my system to work via the schedule only through manually turning each room on.
I have rebooted the Internet Bridge, I have taken all the radiator valves off and change the batteries and put them on again. They paired successfully. I have rebooted the thermostat. Now I don’t know what to do any suggestions?
-
Does the thermostat shut the valve when no rads are calling for heat?
My thermostat is in the same room as a radiator. If I have a smart thermostat on the radiator and it is set at a lower temperature than the wireless smart thermostat will the thermostat shut off the valve or still be calling for heat even though the radiator has shut off?
-
Limitation température à 25
Pourquoi limiter la température à 25 degrés ? Pb hardware ou firmware?
-
How come all rooms are keeping a constant temperature but one room is overheating ???
How come all rooms are keeping a constant temperature but one room is overheating???
-
Wireless thermostat and radiator valves
I have installed a wireless thermostat and two radiator valves. I have the same set up up stairs and on my app the upstairs shows as main bedroom in one box and controls the valves fine. I have now tried to do the same in my lounge but my app shows lounge in 3 boxes instead of only one box. Not sure what I’ve done wrong…
-
Linking to air source heat pump
Do we need to replace the transmitter on our heat pump with the Tado one or can the smart thermostat link to the existing one?
-
Setup Tado smart ac control v3+ without original IR remote?
Hi, I'm thinking of buying a Tado smart ac control v3+ for a duct system mounted in the ceiling. The brand is Haier, currently controlled via a wired remote on the wall. The wired remote has an IR-eye but I dont have any IR-remote. From what I've read it seems like I need an IR remote to configure the Tado? Will I not be…
-
Compatability with Vaillant Combi Gas Boiler
I have a Vaillant ecoTEC plus combi boiler with a vSMART wireless controller, I'm considering installing a tado system with at least 6 rad controllers. My question is ; is the tado system compatable with my Vaillant set-up The tado compatibility chart suggests it is, see attachment, but before I commit to £350 worth of kit…
-
Replacing existing wired controlling and programmable thermostat
I have a Worcester Greenstar 24i system boiler connected to a Honeywell ST2400C controller which is connected to a Honeywell CM907 programmable thermostat. I do not know if the current wiring to the programmer etc is via a wiring centre as the wiring from the boiler to the controller is boxed away and access extremely…
-
App on saying heating but no warmth in rads
Hello! First post, I tried searching for this but couldn't find anything so apologies in case this is a frequently answered question! I have the Tado in the room I am in set to heat to 20c, it says it's heating (and is shaded on the little chart) but the temp is not going up and the radiator is cold. It's currently 13.4c.…
-
Hur kan man undvika att riktningen på luftflödet ändras på IVT aero vid start.
How can you avoid the direction of the air flow changing on the IVT aero when starting and stopping.
-
Extension kit is completely dead
My Wireless Extension bridge, or device, the one connected to the heating system and the electrical supply, is now dead. I have tested both the cable from the plug with a measuring instrument and it shows 240V on the poles of the device, also there is about 80V coming from the heating system on the heating system relay…
-
Heating rooms individually without having to turn on main thermostat
Hi, Just need a bit of help please, just installed the tado kit and trvs yesterday, all works fine but I'm struggling with one thing. Can I just slide up in the app let's say for bedroom 1 and then the boiler gets triggered and turns on? Right now I am having to do the following: Turn up the main thermostat and then…
-
Maximum Boiler Temperature Fail
Set my open therm maximum boiler temperature to 60 degrees a two days ago and checked the boiler flow and return temperatures which, at a point, were 59 and 32 degrees. Just checked this morning and they were 80 and 65. How can this be?
-
Why does one particular radiator come on whichever room I try to heat?
Hi, I have a Wireless Thermostat and two radiator thermostats in my dining room. I also have radiator thermostats in our three bedrooms, the bathroom and the living room. In the evening, I just want to heat my children's bedrooms, as we have a woodburner downstairs. Whilst I can heat the two bedrooms, one of the radiators…