-
Can a Zone controller operating a zone valve also tell the boiler receiver to fire the boiler?
I'm sure this has come up before but, I have 11 Tado TRVs, 4 on the ground floor plus another 2 in the same circuit/zone in the 1st and 2nd floor bathrooms. There is a wireless thermostat in the hall (controlling the TRV on the hall radiator) and a receiver wired to the boiler. I had an old timer wired to a zone valve…
-
tado klant
-
Temperature regulation quality
My Tado controls my dated boiler/heater which has no OpenTherm, so it's modulating. I noticed that after some time the accuracy of temperature regulation improved - at least it looks like that on the screenshots below - correct me if I am wrong. Better quality of regulation is better indeed, but on the other side I see…
-
Which mode is better for the heater?
My Tado controls my dated boiler/heater which has no OpenTherm, so it's modulating. I noticed that after some time the accuracy of temperature regulation improved - at least it looks like that on the screenshots below - correct me if I am wrong. Better quality of regulation is better indeed, but on the other side I see…
-
Why is the pairing link now blinking?
How do I stop the pairing light on my internet bridge from blinking?The other three lights are on and the thermostat shows they are paired,it also says pairing activated.
-
Tado radiator turning on by itself outside smart schedule hours
The last 3 nights 1 of our Tado radiator valves has been turning itself on and heating our bedroom at around 4am. The smart schedule we have should only allow it to turn on at 6:50 am and off again at 07:15 am. I've not made any changes recently and it's been running smooth and consistent since last year when I changed the…
-
Terrible Customer Support
-
Advice needed, please: should I buy a refurbished Tado?
I have looked closely at the Nest Learning 3 and Hive V3 thermostats for my two-bedroom large flat with a Vaillant Ecotec 824 Plus gas combi boiler. To buy a Nest or Hive and have professionally installed would cost around £250. However it's possible to buy a Tado refurbished Wired Smart thermostat starter kit for £99.99.…
-
What happens if the internet fails when I am not at home?
If I go away for, say, a fortnight and home internet is down, what will my heating do? Obviously I would like it to fall back to some kind of frost protection mode. My internet is 4g based so I sometimes unplug and take it with me. Same question for hot water. It would be nice if it's not stone cold when I get back but not…
-
Unreliable thermostat
My thermostat is just out of its 2 year warranty, and is frequently losing its remote connection. Tado cannot help and suggest it is replaced but this makes it an expensive system. Have others experienced similar unreliability problems?
-
Can I set the schedule for all days of the week through the API?
Hello I'm using the TADO API to set the schedule for various days of the week. The schedule for each day is different, so the zone in question has the timetable type SEVEN_DAY. So far I'm setting the schedule independently, sending a PUT to:…
-
How to control (on/off/temperature) hot water from thermostat
Room temperature can of course be controlled from the device itself. When you switch on/of hot water or change the temperature, the device shows you with the white LEDs. But how to control hot water directly on the device? Background: I have quite a popular house as it is not to far from the see. Every now and then family…
-
Setting Boiler Schedule and Temp
Hey there, I have Setup my Tado thermostats on the radiators and the gateway. Unfortunately there is no thermostat from Tado to Controller my boiler according to the product selector. But my boiler has a display where I can set temp and schedule …. How should I set it?
-
Re: tado klant
-
Boiler won't turn off
Hi All, Got myself setup with a Tado system throughout the house, but it seems that the boiler won't switch off, even when I tell Tado to turn off all rooms. I'm not sure if it is a wiring issue or not. The setup is: Boiler for hot water and heating Hot water tank 3 heating zones downstairs for wet UFH with 3 x wired Tado…
-
Mitsubishi Ecodan ASHP
I have just installed a Mitsubishi Ecodan ASHP and therefore the Tado bridge, Extension box and Wireless Thermostat which were used for the gas boiler are redundant. All radiators have manual thermostatic valves and these are now the only room temperature controls.. I don't think it is practical to try to use the Tado…
-
Moving from Nest wireless downstairs with upstairs wired thermostat
Hi, Our Nest packed it in, so I’m looking to shift to Tado but I’m unsure about what to buy. Our setup is this: Originally our Grant Multiboiler had two wired (Honeywell) wall thermostats, one upstairs and one downstairs. This was changed to a downstairs wireless Nest with the heat link installed at the boiler. (The…
-
Good news or not for Tadoº users ?
https://www.tado.com/de-en/press-releases/GFJ Should we worry ?
-
TRVs in Every Room and Extensions Kit Question
Hi all, I have a boiler with a single, wireless thermostat. I have a single Tado TRV and Tado smart thermostat and planning to add more TRVS/smart thermos. My question is, if I add TRVs to all radiators do I need an extension kit? Can I just set all the temps on the TRVs and switch the boiler to "On" and stop using the…
-
Hot water after hot water request via faucet
Hi all, We are considering to step into the tado system with the smart valves for most of our radiators. The main reason is that when I work at home, I only need heat in my office room while 5 other radiators are warming up the living room and kitchen. According to what I read, it should be possible to save a significant…
-
WB CDi weather comp/load comp and modulation with tado
Hi, I have a wb CDI boiler with full tado setup Inc trvs, extension kit and wired thermostat. I'm just now starting to look into more technical areas of heating controls and am seeing things about weather comp and load comp and boiler modulation. If I read right, tado can modulate the boiler but it must be wired into the…
-
Config Menu ID for Ideal Vogue Max System
There doesn't seem to be a corresponding "Config Menu ID" for the Ideal Vogue Max Bioler which mean I can't up my thermostat. Please advise (urgently) on how to proceed.
-
Ideal Vogue Max 32 - Wiring the Tado thermostat
Hi all, my boiler has just been replaced with an Ideal Vogue Max 32 boiler. At the minute the Tado thermostat is not communicating with the boiler. Does anyone have any instructions on how to wire it up? I can’t find any instruction though the app for this model. I originally had a Worcester Wave thermostat which I…
-
Care & Protect - not reporting boiler errors
I’ve recently invested in a tado system and the subscription service. The boiler in my home was not firing and no heat to rads or hot water was available for 3 hours until I noticed the issue and reset it. However, in the Tado app no error was picked up despite the temperatures in respective rooms being well under target…
-
No battery warning from hard-wired Wall Smart Thermostat’s
Hi all, Just wondered if anyone else has had this issue like me? I recently went to a wall thermostat to check the room temperature and noticed the display was not working correctly and very erratic. I checked the device in the app but it was showing the batteries as been “good” and the device also still controlled the…
-
DNS queries gone crazy
Has anyone noticed their Tado doing way more DNS lookups than normal? My Tado Internet Bridge has been doing a DNS lookup for ingress.tado.com every few seconds today, with nearly 5000 requests so far today. This is new, with a lookup every 5 minutes or so prior to today. Firmware version 60.6.
-
Geofencing
Hi guy’s n girls. Having problems with the geofencing not working. It’s use to work but now it doesn’t, I’ve tried numerous thing I had it installed on an iPad, iPhone, and the wife’s iphone. I’ve signed out of all the devices deleted the iPad app and the wife’s iPhone app only installed now on my iPhone gave tado full…
-
Smart Thermostat - call for heat permanently on
Have had a Smart Thermostst on test for over a year to see how reliable the whole set up might be. Decided to take it live it today, but find CH permanently on. On removing the ST and testing continuity it is evident that the NO contacts are permanently closed, batteries in or out, and/or no matter what setpoint is set.…
-
Please help before I have to return all the kit?
Hi, brand new setup here. Got the tado smart wired thermostat connected to a valiant eco tech pro 28 (Older model) It’s currently replacing the wired thermostat from valiant and just using the ebus + and - wires. My problem is when I set the device to d07 which I believe is required to operate my boiler the unit basically…
-
Connection issues
I don’t wether it’s my BT Router or Tado I’m having issues with. The boiler just comes when it wants to even though the house is warmer than set. I’d understand if the room temps were low but they’re not. I bought 3 radiator thermostats connected them thinking this will help but no still the same issue. The new updates are…