-
Zones and Rooms
Hello I emailed support for two months no reply. I have set my todo in rooms. I have 15 tado (thermostats and wireless temperature sensors) Rooms have their specific units. However, I am not sure. Are rooms zones? I see some YouTube the Tado app has zones. What about I want two rooms in the same zone? Or the upstairs floor…
-
2 heating zones?
Can I add a 2nd extension kit receiver to my starter kit to give me contol over a 2nd hearing zone? Originally, I have 2 Salus RT520RF room stats controlling 2 heating zones ( combination boiler ) via 2 x 2 port zone valves. All working perfectly but I wish to upgrade to a more flexible SMART system. I have read many posts…
-
Boiler (heating) turning itself on
I’ve recently installed the wireless thermostat, wireless receiver and four radiator valves. Very happy with the system until: 04.30 (UK time) today, the boiler turned itself on and started heating the house. Per the tado system: -Everything should have been off (not timed to come on until 05.30) -Everything was shown as…
-
Electrics keep tripping
Plumber came to fit a new boiler - replaced conventional with system. Took away honeywell thermostat and British gas control board. Sadly I don't have any photos of the original setup. Fitted the v3 kit plus wireless connector. Plumber has written the following; Rcd (lhs) circuit trips when earth connection is made to the…
-
Internet Bridge - Low power
Hello, power station? Can I have more power, please? xD
-
Controlling zone valve with smart thermostat (wiring question)
I have an extension kit connected to the boiler, Tado trvs on all radiators and one tado thermostat. They can all call for heat independently. Now, I have a 5 wire zone valve that I want the thermostat to control. But I have no idea how to wire it? Am I correct in thinking the thermostat can call for heat wirelessly and…
-
Glow worm Ultracom 2 sxi with zones
Hi, I'm new to this forum, so hello! I'm looking to replace my old Glow Worm controller and thermostats with a Tado system. I was drawn to Tado because of the Smart TRVs, which I will slowly replace my manual TRVs with after I install the main Tado thermostat. Currently our house has two heating zones, controlled by…
-
Problem fitting extra Tado Valve in a bedroom
I have already fitted a tado control system which all work perfectly well. I now want to replace a manual Danfloss TVR in a bedroom. But I cannot select a suitable fitting I have shown a picture of the valve with the Danfloss valve fitted and removed. To me, it looks like the valve is fitted with a Danfloss adaptor. Can…
-
Offline rads
I keep getting “offline” notifications for mainly 2 of my TRVs. The batteries are brand new out of the box. Unfortunately our modem is a one end of the house (bungalow) and the troublesome rads are the furthest away so I assume this has to do with the distance from the bridge and modem. How do I fix this? (I am a…
-
Vaillant VR65 with eBus and system boiler - hot water works but heating doesn't
Hi, I've just installed a Vaillant EcoTech Pro 630 (system boiler with two zone valves and a vented HW tank) and have added a second-hand Vaillant VR65 wiring centre as I read on here that this is the way to make the V3 Extension Kit talk to the boiler via eBus. Has anyone done this successfully and can you tell me how you…
-
UFH Question
Just moved into a new house and brought our Wireless Starter Kit V3 with us since it worked well in our last flat. I also purchased 8 Smart Radiator valves to go on all our radiators so that is all working well now. Over this fairly cold spell we have just had our living room has been freezing. The seller said it has…
-
Manual operation
I've bought a Tado v3 for a holiday let so I can pop the heating on when it's empty. I've not installed it yet but I was wondering, can you turn the heating off on the thermostat or just reduce the temperature? If you can only reduce the temperature what is the lowest setting? Thanks 😊
-
Why does Tado store location data for 2 weeks?
From the Tado Privacy Policy: ”We will keep your personal information for as long as you have an account with us. After you close your account with us we will keep your personal information for a reasonable period to maintain our records and legal obligations to you. Sensitive personal information such as location…
-
Heating Water
I have a Megaflo system and am wondering if Tado stops heating the water once the water is fully heated BUT the time schedule hasn't been reached?
-
Thermostat switched off but radioator is warm and keeps heating
I have 4 smart thermostats installed. Last week, even though all smart thermostats were OFF, the radioator in the living room was warm and we could notice the room temperature as higher than expected. I did the reset procedure, expecting it to be a calibration issue. It did not help. I then switched that thermostat with…
-
Is it possible to control the 24V fan under the water radiator using a wired smart thermostat?
I have a water radiator at home with airflow from the bottom, model Regulus Revers. The fan is mounted on the bottom of the radiator, powered by 24V with variable speed. The fan speed can be controlled by applying a voltage in the range of 0-10V to the control line. The radiator has also a thermostat SALUS T30NC 24V DC.…
-
Extension Kit not Calling for Heat - dual zone install, old install but new problem
I've had Tado for a few years now. My set up was installed professionally and is dual zones; Wired Smart Thermostat - Controls the underfloor heating circuit in the kitchen Wireless thermostat linked to Extension Kit - Controls the radiator circuit. There are then SRVs on each radiator in the house Just yesterday the…
-
TRVs Without actuators
I am upgrading a whole heating system using a new TADO system with TRV actuators which I have. I want to install new TRV valves but don't want to buy 12 TRVs with manual actuators and then throw 12 actuators away. Does anyone know where I can buy good quality TRVs without the actuators? Or do I give up on TADO?
-
Smart TRV whistling
I have had several smart TRVs in the house without issues. Recently I bought a pack of the newer basic TRVs to cover more rooms. I wanted the smarter TRVs in the bedrooms so switched out the existing sitting room for one of the new basic ones. Suddenly the valve started whistling loudly when the radiator was on. I swapped…
-
Tado and HomeKit Controller Question - TRVs and Wireless Sensors and Hot Water Control
Hi All, I am about to integrate Tado into HomeAssistant via HomeKit controller to allow for local control over my system and I have a couple of questions before I dive in. In some rooms I have TRVs and wireless temp sensors. Obviously using this through the cloud this is seamless you place the TRV and temp sensor in the…
-
@Tado. CONTROLLER WON'T SWITCH TO OFF!
Hi all, If Tado or anyone with similar experience can help me or train me, I would be very grateful. My simple heating system functions correctly when the original Drayton controller is connected. As it did before the Tado system was fitted. So there are no stuck relays or faulty valves, and no TVRs to consider in this…
-
Offline
See we are having another period of Server instability leaving my controller offline and my house heating to melting Same thing over Christmas that miraculously fixed itself when everyong went back in January. Course Server status is up - like it always has been - no down time, hard to beleive!
-
Smart TRV help
I have a TADO V3+ WIRELESS HEATING & HOT WATER SMART THERMOSTAT STARTER KIT to control my central heating. Can I purchase the Tado smart TRV as an addon? Will the smart TRV fit my radiator which currently has a manual valve coming in to the radiator and the bottom. All the pictures it.appears at the top of the rad.
-
Flowmaster trv compatability
Hello everyone thanks for the add anyone fitted the smart thermostat trv to a flowmaster trv? Thanks again Steve
-
Keeping device stickers...where?
Tado helpfully supply a couple of pages in the Setup Guide in which you can paste the id stcikers (with qr codes) from your devices. Unfortunately it only has 14 slots, 2 for the Internet Bridge and Wireless Receiver and a further 12 for other devices. My large system has a further 17 items, and I don't have enough room to…
-
v2 to v3 bridge questions
I have been running a v2 bridge without issue for a good few years. However, I now have a new device that is out of range and wondered if I would see any benefit to upgrading to a v3 bridge. Do these have a stronger radio / greater range? Also, if I was to upgrade the bridge, can the old bridge still be used on a new…
-
Low battery causing heating to come on - no low battery indication
We have Tado rad stats in most rooms, but not the hallway so any time heat is called for, it heats a portion of the house. In the last month we've had 2 stats cause the heating to be on full power as the battery's aren't good enough to open the valve, but good enough to call the heating. No warnings or low battery…
-
Reset "learning" after heating system overhaul
Hi all. We've recently had an extension built on our home, which included replacement and re-piping of several radiators, installation of some new ones, and installation of a new boiler as well. The boiler is wired to a tado extension kit via OpenTherm, and appears to be working as expected. I wondered though if all of the…
-
Smart Room Thermostat choice ?
Hi, I am in an apartment with a shared central heating system. This means that I have to set the temperature per radiator. My radiators are built into a closet with front opening , incl. the taps. So it gets hot(er) fairly quickly there than in the room. So I thought I would install a Tado radiator thermostat valve on it…
-
Radiators only heat up if water is also set to be on
We have a relatively simple gas central heating set up. A traditional but NEW gas boiler (not combi), with TADO wireless receiver, internet bridge and wireless temperature sensor/controller. The controller is in the main living room. None of the radiators have TRVs We have found that whilst we can have hot water (ON) only,…