-
Configuration Help
Hello, i have recently fitted the wireless starter kit to my system boiler set up (Y plan). All wired up correctly and heating works like a dream. My issue is that my hot water will not work. I cannot change the configuration on the wireless reciever to Y plan (green), every time i set it to green it resets it self to…
-
Is the wired starter kit all I need?
Hi, I've got a Honeywell ST9400C controller that has a physical wire connection to a thermostate in my hall and a physical wire connection to my hot water cylinder. The cylinder has a thermostate on it and the boiler is oil. The ST9400C has a House Heating side and a Hot Water Heating side ie the hot water and heating work…
-
Replacing old Danfoss equipment
I have a Danfoss RX1 with wireless thermostat. These are linked to a Danfoss FP715Si controller. Will it be possible to replace the RX1, thermostat and FP715Si with a Tado V3+ starter kit? Installation instructions allow me to choose RX1 or FP715Si but not both.
-
Boiler won’t switch off
My heating turns on via the app fine fires up boiler no Issues heats up rads. When I turn off via app it shows switched off however boiler still on. Anyone experienced the same issues before? I have to switch off boiler then back on and it goes back to normal. Not healthy to keep switching off boiler but then heating will…
-
Help wiring Tado Hot water receiver
Hi, I'm trying to install Tado myself and I ran into something and would love some help. I live in a new build. There are 2 zones for heating and 1 for hot water tank. There are 2 thermostat (ground floor Honeywell home analogue and upstairs Honeywell Cm707. Lastly I have 1 programmer (Honeywell ST9400C) which is…
-
Using the tado° system
Hi, I live in a seven-year-old three-story townhouse. I have an Ideal gas boiler (logic Heat 12) with a separate hot water tank. A Honeywell ST9400C controller and a wired analogue Honeywell thermostat, (possibly a T6360B). All but the hall, and two landing radiators are fitted with thermostatic valves. The thermostat is…
-
Honeywell ST9100C Hot Water Controller and Honeywell CM907 Wired Thermostat
Hi there, Similar to annother queston but in this case I have a single wired thermostat for the home central heating control. Having read a bunch off information from various forums, would I be correct in thinking that the Tado syste I need to replace both my Hot Water Controller and Central Heating Thermostat is the…
-
Installation issues and Tado is ignoring messages
Hi I just bought a wireless thermostat and have issues installing the receiver as I cannot find the exact electrical "piece" in the instructions within the boiler. There is nothing exactly the same. Main Eco Elite 25 I have contacted tado chat three times and the only reply I get is we will get back to you by email - which…
-
Modulating Vaillant
Hello Just checking other peoples experiences with using the ebus system on the Vaillant boiler I have a Ecotec plus 824 using the Tado smart thermostat linked to the EU wireless receiver When getting up to temperature the system works perfectly but when it ticking over its firing for about 10 minutes at a reduced flow but…
-
need help with multi-zone heat control
Hi everyone, I have a question regarding multi-zone heating, The scenario is that I have a 3 story house. I have a single smart thermostat (wired) in the ground floor with an internet bridge. I cannot use `smart radiator thermostat` since it is all under the floor heating and there is no valve available. The ground floor…
-
System layout
I have followed these threads with great interest - and some confusion. I would be interested to hear other users' observations on the following: I have a 1963-built 3-bed bungalow which I have refurbished/extended to create a partially open-plan ground floor layout with one bedroom and study plus a small en-suite bedroom…
-
TRV and thermostat???
Hi, I have Tado TRVs and a wireless thermostat. I am probably being thick, but what use is the thermostat if all my radiators (except 1) have the smart TRV on them? Thx Gerry
-
Why is heating coming on in rooms set to 'off'?
Whenever I set the lounge radiator to say 19c (radiator smart thermostat), but want the main thermostat in the hallway and other rooms set to off (wireless smart thermostat) to save money, the system seems to heat all rooms regardless (rads are very hot to the touch). Surely the point of Tado is that you can heat only one…
-
Replace wired Neura Therm thermostat/s with wireless Tado set up
Hi all Current Setup: I have underfloor upstairs and downstairs. 1 thermostat upstairs (bedroom) and 1 downstairs (hall). Both thermostats are Neura Therm brand with 2 wires connected at the back. The heating system is a ground source geothermal heat pump (pipes underground in the lawn). When the thermostat calls for heat…
-
Set Room Type
Hi all, i have smart TRVs in every room, apart from bathrooms. I find the air quality section really useful. The only thing I am unable to find a setting for is to give a room a "type" for example living room or bedroom. I feel this would give the air quality section greater accuracy as the ideal temperature for a bedroom…
-
Dual zone heating and hotwater
Hi all, I am looking at installing Tado into a dual zone heating system with a hot water cylinder. From the site I've read that I need a wired starter kit and an extra wired thermostat but this doesn't give me the ability to control the hot water, all it does is essential replace the wired dumb thermostats with ones that…
-
My boiler failed yesterday, should I get some alert from the Tado App?
Hi, My boiler failed yesterday, should I get some alert from the Tado App? The app seems to think that it is still heating my house, even though the boiler is switched off awaiting replacement parts to be fitted. Also, the app heating graph still shows all rads being heated, until I switched them all off via the app…
-
Worcester 8000 and TADO—extremely confused
I have had a whole house TADO system for a few years and have love it. Today we had an 8000 life installed and the installer informed us the boiler is not compatible. Sadly, after he’d already installed it, otherwise I would have told him not to. Reading the groups some say it’s just completely incompatible due to TADO not…
-
Wireless Starter Kit V3+ can it be wired?
Hi, I have an older V2 thermostat that I know can be used as a wired or wireless with the hot water/programmer replacement box. My Sister is looking to buy a new V3+ on and I see 2 versions. The wireless one with hot water is on offer, but she has a combi boiler with a wired thermostat - does this new thermostat have the…
-
Thermostat stuck on configuration download
Our tado installation is 2 years old now, no recent change to our set up - but we have no heating in the upstairs zone at the moment because the landing thermostat is stuck on 'configuration download'. It's been stuck there for hours - and it's freezing upstairs. Any suggestions on how to fix this?
-
Additional weather compensation probe
I live in a 19th-century granite building. Heating system - Alpha Innovations e-tec 33 boiler is managed by Tado. Does it make sense to install an additional weather compensation probe 3.022383 as an additional measuring device? Thank you in advance for your suggestions Tom
-
Newbee Question - Does my Thermostat Have to Call for Heat for Other TRV Rads to Work?
My Set up: Tado Smart Thermostat in hallway (for 'dumb' radiators in the hallway, bathrooms, kitchen and spare bedroom) 4 x V3 Tado TRVs, 3 in bedrooms upstairs and one in the living room As I work at home, I only want one of the bedrooms (doubles as an office) to heat up during the day. I've set this as an independent…
-
Please help - away mode failed
Today we were out all day, and everything was set to away (frost protection only). The app shows that no heating was on all day in the energy graphs, despite showing that the heating increased in all rooms. However, in real life the heating was on, and it cost over £10! I have the Loop app and it shows consistent gas use…
-
What devices do I need?
Hi, I currently have a Logic Heath h15 Boiler with a Danfoss controller next to it and separate hot water tank. I then have a wired danfoss thermostat in my hallway and a wired danfoss thermostat in my bedroom. Can I replace the wired thermostat upstairs with a wireless starter kit and then have an add on wired thermostat…
-
Please help hall radiator not getting warm
Please can someone help. I have got no response from tado chat. We have a radiator in the hall that has no tvr fitted. There is a smart thermostat on the wall that should act as the temp control for that radiator. We have the wireless thing in the kitchen and tvrs on all other radiators. All the radiators call for heat…
-
Returning Tado product
I am returning SRVs and Tado have asked for copies of the shipping docs. How do I return jpg copies to Tado?
-
Two Zones - Two Wireless Thermostats
Hi, My current heating setup is two heating zones (plus hot water). Ideal boiler driven by two wired Siemens thermostats and a single dual programmer in the garage with the boiler (plus a separate programmer for hot water). I would like to replace the wired thermostats with wireless ones (as they’re in the stairwell on…
-
Smart AC Control v3 and AC w. heating
Hi, we have a Tado to control our central heating. Works great. Now we’re getting an AC unit installed that can cool and heat, although cooling is what we’re getting it for I’m wondering how that works with the Tado we have. Will Tado use the heating as well? I.e. adjust desired room-temp ‘up’ for the AC unit? Should the…
-
Vaillant Ecotec Plus 835 + ebus | Set partial load to 'auto'?
My current thermostat is a Honeywell T4R. It offers simple on/off control of the boiler. The installer left the boiler's partial load set to 'auto' and that caused quite a few problems with flow temperature and anticycling. I manually changed the partial load to match my total radiator wattage, which it got things working.…
-
Combi Boiler - monitoring hot water
I've recently installed the tado v3 with the bridge etc. Finding it great, but wondered if there was any way of connecting the hot water side of the boiler to monitor the energy use?