-
Leaking valve
Hey all I’ve noticed that a few of my valves has small leaks. I’ve tried tightening them up by hand but I’m wondering if I need to use a wrench to do it instead? Could there be any other reason for small leaks? Cheers
-
Optimising my set up with Opentherm
Hi, It’s such a knowledgeable forum I’m hoping I can get some advice to make sure my setup is fully optimised. My setup is as follows - Veissmann Vitodens 111-W - Tado Wireless Extender Connected to boiler by Opentherm - Ground Floor - Room 1 has 2 x SRTs controlled by 1 Wireless Temp Sensor. Other rooms have no Tado…
-
Can I use Tado smart thermostats with Tuya smart TRVs in Tado app and with tado hub?
I have bought a house with several smart TRVs already installed and attached to a Tuya hub. I want to have a complete smart system so I’m thinking of installing a Hive or Tado hub and thermostat. But I want to be able to integrate the existing Tuya TRVs into the Tado system. Is this possible or will I have to control them…
-
Multiple Bridges, Single Account
I've asked this before, but I'm not sure I ever got a response. I know currently it is not possible, you need two accounts, which makes absolutely no sense. Are there any plans to change this? Am I looking at changing all my TRVs to a solution that does enable this? OR... is there a way of improving the range and…
-
Is my old version of the Internet bridge & thermostat compatible with v3 extension kit
Good evening all, I have one of the 1st starter kits consisting of a Internet bridge IB2853046784, wired thermostat RU2332166656 and wireless extension kit BU2178746624. I'm not sure what versions the hardware is. I'm thinking I need to replace my extension kit as it has an intermittent fault I need to know if the new v3…
-
Swapping faulty extension kit for wireless receiver, wiring problem
Hi all I think my extension kit is faulty with an intermittent fault sometimes it doesn't turn off the boiler even when it is commanded too. I have bought the new v3+ Wireless receiver but the terminals are labelled differently to the instructions for the extension kit I need to know which wire to put to which terminal on…
-
UK | Tado Frost Protection + Home Insurance = Not fit for purpose
I've just discovered that Tado frost protection defaults to a 4ºC. Most UK home insurance policies insist that a home is heated to 12ºC to avoid burst pipes (e.g. those hidden under suspended floors in older properties). There is no way to change this setting. If you manually turn off your heating and manually set the…
-
Comb boiler and rad full open
I seem to recall this ages ago-if using a combi boiler is one radiator meant to always be left fully open eg without a TRV and if so, is the outflow meant to be fully open as well?
-
What exactly does the high/ medium /low heat request do?
Does anyone understand this support page: How do I know how often tado° turns my heating system on and off? https://support.tado.com/en/articles/3478984-how-do-i-know-how-often-tado-turns-my-heating-system-on-and-off It says it shows: "heat request symbol as a number of wavy lines with 3 being a high heat request, 2…
-
Drayton Auto Balancing Valves
Both types of these valves are supported by tado according to their fitment list (no adapters needed) but just wondered if we have any early adopters on here or anyone reviewed and dismissed them. Body only kits are available about £25 in UK.
-
Minimum requested flow water temperature
Hello, Does anybody have any measurement what is the lowest flow temperature value the Tado thermostat may request from a boiler connected via OpenTherm ? Does it go below 30 C ? Is it affected by any means if you configure that you have UFH in the system ? (as with UFH you may use really low flow temperature)
-
Energy Tariffs Setting
There is an option to set the cost of your daily usage. However there is no option, that I can find, to allow the daily standing charge to be set. I need usage * unit charge + daily charge. Can anyone help?
-
why does my question have to be approved?
Ive just posted a 15 minus write up question - it says it has to be approved. Can a mod please have a look and give me feedback as to whether theres an issue?
-
Wireless underfloor heating
I have a fully set up tado system across all of my house (rads in every room) except for my kitchen, which has UFH, where the heating is controlled vi a wireless non-tado thermostat. I want to add the kitchen to the tado set up so I can see usage through the app and control the heating remotely. However everything I’ve…
-
Heating on all the time since installing
Hi, We installed a Tado thermostat and 8 radiator TRVs in our home a couple months back. Since installing them we are finding that it is causing our boiler to be on most of the day (averaging 22 hours of the day). The boiler is switching on to heat 1 room them once that’s up to temp, it switches off but then another room…
-
viessmann vitodens 050-w and Opentherm
Hi, I've just had this boiler installed and want it to use Opentherm which the boiler is compatible for. The old boiler didn't have modulation. I've had the tado system for around 4 years now so have the below setup: extension kit which is wired directly into boiler. internet bridge. 6 wireless radiator thermostats. 5…
-
Does scheduling hotwater on Tado app help reduce energy consumption rather than keeping it turned on
Hi, I have noticed that there is a hot water option in the app. But I have never used it. We have a combi boiler. If I turn this off on the app, does it turn off the hot water in the boiler? Can schedule when to get hot water? please can Tado help advise on this? Many thanks, Naren.
-
New user, but can’t get the app setting to hold morning schedule
Just had new Baxi Boiler fittedalong with Tado wireless thermostat. having problems setting morning time schedule on my phone app, evening one seemed o.k. However the Boiler and heating came on at midnight last night! Tried again this morning to alter settings on app. The afternoon/evening one seems to hold now, but will…
-
App werkt maar airco slaat niet aan sinds ik in het buitenland ben.
Hallo, mijn Tadoo airco controller werkt niet. Vorige week geïnstalleerd in ons vakantiehuis in het buitenland. Alles werkte perfect via de app ook als we buitenshuis waren. Eenmaal terug in NL werkt het opeens niet meer. Op de app staat dat de airco aanstaat maar als ik op de camera in huis kijk zie ik dat deze niet…
-
Allow the Wireless Receiver to be controled by multiple thermostats or Wireless Temperature Sensor
For the moment, as I am told by the tado support, the wireless receiver can only receive instructions from one thermostat and from the connected radiator valves. For a rooms which need a constant temperature (such as a bedroom always at 16°C for example), a wireless temperature sensor could be enough and we wouldn't need…
-
Frost Protection turning heating on full
Hello all, I keep finding my heating is blazing during the night while frost protection is active due to the cold weather. I have to turn down the radiator temperature on the boiler to stop it heating the whole house during the night. My understanding was frost protection runs a low temperature throughout the system to…
-
Flow temp settings etc. to save energy
We have a Worcester Bosch boiler and this spring installed a few tado radiator valves, a tado smart thermostat for the whole central heating system, as well as a separate wired thermostat for the underfloor heating in the kitchen. Given the cost of fuel, we want this to be as energy efficient as possible come the winter. I…
-
I've lowered my CH water temperature - my rooms don't heat fully now - HELP
Hi all, I have changed my CH water temperature from about 70 deg to just over 50 deg. I wanted to see how my rads handled the heating of the rooms with the lower temperature, with one eye on needing a Heat Pump in the coming years. In the evening, I run the downstairs thermostats at 22 deg I changed the temperature on 01…
-
Thermostat is off but temperature is going up and up
I got 5 thermostats and if I switch one off completely because I'm not in that room or don't want high temperature in this room the thermostat make the noise to lower the temperature but the room is still heating up. Sometimes I set it on 18C degrees but it climbs up to 22c degrees because in other rooms thermostats…
-
geen warmte vraag indicatie in de tado app ondanks aanklikken icoon
Ik krijg sinds een paar dagen geen staafjes meer te zien en kan dus niet zien wanneer mijn warmtewisselaar (stadsverwarming) wordt aangesproken en hoe vaak. tot afgelopen weekend kreeg ik dat wel te zien, maar nu dus niet meer. de temperatuurgrafiek zie ik wel (en gaat dus omhoog en omlaag) evenals de buitentemperatuur en…
-
Recommended rechargeable battery
Hi. I know there is an ongoing debate about rechargeable batteries but if one _did_ wish to use them which ones would be the best to use? Thanks
-
Tado Wireless Starterkit with Salus Command Center
Hi guys! Recently I've hit a wall when I've bought the Starter Kit V3+ Wireless for my UFH system among two other Smart Wireless Sensors. My configuration stands this way: Boiler: Bosch Condens 2200W 6 Zone wiring center: Salus KL-06 with a PL07 module to control the pump 6 x Actuators: Salus T30NC230 I've connected all…
-
E151 Error with Atlantic Perfinox 4124 BVIR - Impossible to use TADO
Hello, Several issues with my TADO Wireless controlling an Atlantic Perfinox 4124 BVI R boiler. The system is set as OpenTherm. E151 with big noise when the system tries to run the boiler at a very low level. There are 3, it is on 1 that I have a problem with. Difficult to know what TADO is sending as everything is hidden.…
-
Main / Baxi E133 Fault during low temperature in away mode
I had my V3+ kit on with newly installed Main Compact Eco combi boiler. It was working really good on the first few days, while I set it at 20 degrees. However, when I turn it down a bit at night or away like 17 degrees. The ignition light didn’t turn on and it fails then. I checked and observed a few times and found that…
-
Can I turn off my boiler with Tado?
Most of my radiators have Tado thermostats attached but I have a few that don't. One bedroom doesn't have a WiFi signal so I can't use a thermostat there. I have another 3 radiators that don't have thermostatic controls on them. All four of these radiators are on all the time because my Tado app controls individual…