-
Heat Pump Optimizer X and Mitsubishi Ecodan
Can the new Heat Pump Optimizer X be connected with Mitsubish Ecodan heat pumps? Or is the support planned in the near feature? Product compatibiliy checker is not working (even with supported Daikin and Panasonic heat pumps it says they aren't compatible 😂)
-
How to make Tado Bridge X join an existing Thread network?
Hi! I set up Tado X in one location and the bridge joined the existing Thread network (by SmartThings hub). But in the second location there are 2 separate Thread networks. How can I force the Bridge X to join the existing network as in the other location?
-
Hot water settings
Sorry for my bad english, i try to explane and i hope that someone will help me! In my new house a tado thermostat was already installed. Without the Internet bridge (I was waiting to receive it from the previous owner) I could turn on the heating system and raise or lower the hot water temperature. After connecting the…
-
Which Tado Thermostat do I need
Hello, I’m looking for some help. I have a glow worm boiler in my kitchen cupboard and a hot water tank in my airing cupboard upstairs. A Drayton Thermostat on the wall which controls the water and heating, as well as a temperature dial on the wall. How do I know which thermostat I need to control both heating and hot…
-
Error - com.tado.general.address.name.full.required
Tengo este error cuando me dispongo a crear la casa el la APP de tado
-
Priority/importance levels.
I'd like some rooms (i.e. bathroom) to stay at some temperature over night but I don't mind if they are slightly more off the set temperature and I don't want boiler to fire up just for that room. It could be heated up when other room (i.e. master bedroom) needs to turn boiler on. Something like the temperature set to 'no…
-
Replacing old relay box on combination boiler with two pumps and then integrate Tado controller
OK. The charity's building is run by three boilers. The largest is an old Thermecon s190/240 64kw (yes really) oil fired boiler - the centre of my puzzle. About 1x1x2 metres in size, it has a large heat exchange unit with two 40mm brass pipe loops running through it, converted on leaving to 28mm piping. one handling the…
-
Tado X Thermostat - Unreachable Apple Home App
Hello there, First time tado customer here. Previously I only used Eve Thermos in my home. Setup experience The setup was pretty easy. I opened the Apple Home App and scanned to Matter code and I could register the Thermostat without any problems in my home. So I wanted to test the connection so inside the Home App I…
-
Back gesture in app
Navigation in the app would be hugely improved by enabling the normal swipe gesture to go back (on iOS, but probably the same on Android). The software back button is at the top left of the screen which I find awkward to tap.
-
Room devices off-line
Can anyone tell me how to fix this?
-
What sort of batteries do the thermostats take and do they have to be rechargeable?
what sort of batteries do the thermostats take and do they have to be rechargeable ?
-
Wireless Thermostat UK - Opentherm
Same old topic I know, but I can't make much sense of the previous discussions. I have just purchased the wireless thermostat kit and 8 srvs, then I found out only the wired thermostat works with opentherm. After googling opentherm and the potential benefits I now have three options: 1. Set up tado wireless stat and ignore…
-
Boiler replacement
I am upgrading to a new replacement boiler. The fitter will connect it to the boiler as it is now. What other changes do I need to make please? I am thinking of the tado thermostat and internet
-
Confused about UFH & Radiators
I have recently had wet UFH installed. I have a wired smart thermostat connected to this. I have a wireless temperature sensor and TRVs to control the central heating. However I seem to be having a few problems. Please can someone confirm what the 'zone controller' should be set to in the app for the UFH? Should it be none…
-
Logic esp1 35/ESi ESRTP5
I currently have an Ideal Logic combi ESP1 35 connected to two (multi zone) wired ESi ESRTP5 room thermostats. The 2 thermostats are upstairs/downstairs and seem to be wired first to a honeywell valve each which control the 2 zones. The thermostats are wire live/neutral and n/o. Do tado offer a compatible solution?
-
Nest Thermostat and Smart TRV's
Hi guys, I have a 3rd gen Nest thermostat with a single zone. The thermostat is in the living room so therefore will generally turn off the heating before the upstairs reaches the same temperature. If I installed the smart trv's would raising the stat temperature do something higher than the trv temps resolve this issue?
-
Tado X
Good morning, I would like to have some clarifications regarding the new Tado X: Can it be installed in a system with a condominium boiler with underfloor heating (water)? Isn't there a manual where it is possible to see the assembly with the connection of the wires? What are its functions of use? Can it be set so that it…
-
Setting up Hot Water Control
Hi, Here in the UK I have an old fashioned gravity fed heating system with a hot water cyclinder, so I cannot control the hot water system separately from the radiators. However, I’m thinking of getting that changed to a so called fully pumped S plan system which will enable me to control hot water and heating separately.…
-
How to swap Drayton LP522 and Salus to Tado
Moved into a new home which has Glow Worm Energy 30s boiler, Dayton LP522 controller which controls hot water and central heating with wireless Salus RXRT505 which controls central heating. This set up also has Dayton twin channel motorized zone activators.…
-
Contact to support seems more difficult
I've been using Tado for about 4 years now and I've always been able to contact the Tado support to help me out with wiring or compatibility questions. I've just now had another question and found out that there is no contact form anymore and that we have to use the rather useless chatbot (we can't even ask a freeform…
-
Glow worm ultimate 3 30c open therm
Hi all, Would anybody be kind enough to confirm wiring for the above boiler for opentherm? Currently wired with dumb thermostat. Assume I should be using the “bus” as opposed to the RT and 24v terminals? Ie CH COM -> BUS CH NO -> BUS Does the B.off link need removing? Thanks
-
Tado vs Hive (Radiator valve only)
Hi everyone, I’m currently looking to purchase radiator valves to use with my existing Hive thermostat. I’m deciding between Hive valves and Tado ones. Hive has a sale going on, and I believe Octopus customers can get a 40% discount on Tado products. My main priority is integrating these valves with HomeKit for automation,…
-
Moved: proefperiode Auto-assist V3+
This discussion has been moved.
-
Merged: Radiator Thermostat in Black
This discussion has been merged.
-
Black radiatorknob
I would like a Black radiatorknob on my Black bathroomradiator. I think it is strenge that is not available when a Black radiator is very common these days.
-
I have central water heating system and do not have boiler in my home.
Hi All, I have a district (central) heating system in the NL. And my thermostat is very much mediaeval :) meaning that it only works with on/off (there is temperature scale on thermostat but it is not functioning). When I turn thermostat on, it turns on all the radiators and cannot be set target room temperature. I can…
-
New install but wireless receiver will not pair what can I try?
I have set up the thermostat and the bridge which both work fine but the wireless receiver will not pair to the bridge, just blinks fast then goes solid but app won’t let me continue install saying it’s not paired, then error light comes on
-
Interaction between (Wireless) Smart Thermostat and SRV
HI, Just installed partial Tado system using (wireless) smart thermostat starter kit + a number of SRV (not yet all fitted). I'm trying to figure out whether I should have an SRV on the rad in the room in which I have the Smart Thermostat/Temp Sensor placed. And if so, what the role of the Smart Thermostat really ends up…
-
Tado & OVO
My daughter purchased a wireless starter kit from a chap on E-bay - unused. I installed the internet bridge, set up an account for her and tried to add it. The camera wouldn't open so we added it manually and it came up with the message "You are installing a Tado provided by OVO" When I clicked on continue the next screen…
-
Best setup advice - 2 wired thermo / 2 zone heating no seperate HW zone
I've currently got two tado wired receivers. Need to replace boiler controller so purchased Wireless starter kit, which has controller for 1 zone / HW and includes wireless thermostat and bridge. As I've only got two zones (and no separate zone for HW) can I just wire one zone into HW, controlled by wired thermostat and…