-
V3+ attempting to modulate even though it's a relay?
Hi all! Installed my V3+ wired thermostat over the weekend and this morning was the first day it was cold enough to need to fire the boiler. Unfortunately it didn't go well :D The boiler came on for 7 minutes then turned off - not reaching target room temp. It stayed off for a while then came on again for another 7…
-
Tado X Thermostat - Matter - Humidity
After adding my tado x thermostat to Apple Home via Matter I can see the temperature reading from the thermostat but not the humidity in my Apple Home. Current Matter standard (1.3) supports exposing humidity readings from a thermostat device type. Is there a particular reason for this? will it be exposed in the future? It…
-
Air Comfort
This seems to be a waste of time, it worked for two days after I installed Tado but now not at all. I’ll have my windows and my back door open for hours on end and the “smart” thermostat doesn’t recognise this. The app shows no open window detected and an increase risk of mold. It’s a bit of a gimmick, I think.
-
Mention remove the existing wireless receiver
Hi all, just installed the wireless starter kit v3+. The installation instructions for Viessman Vitodens 100-W B1KC did not say anything about removing the old wireless receiver. It would be nice with a little mention on that :)
-
Merged: Setting to keep the valves fully open in summer
This discussion has been merged.
-
"Summer/Cooling mode" for wall thermostat
Hi there, I have an underfloor heating with a cooling function. In summer, cool water can run through the floor to cool the room. For that I currently need to set the temperature to max (25°C) to keep the thermostats open. If the room temperature would rise above 25°C the thermostats would close and prohibit a cooling…
-
Thermostat reading
My thermostat is reading 22c but it’s no-where near that, it’s cold in here. Any one else having or had this problem?
-
Tado and Viessmann Vitodens 100W B1KF (New Install)
Hi all, Hoping to get some help with my new install. Recently had a Viessmann Vitodens 100-w B1KF combi boiler installed. Boiler is working fine as expected, it is set up using weather compensation and I have installed the external temperature sensor. I installed the Tado V3 kit with the follwing installed: Internet…
-
Compatibilità sistema riscaldamento a pavimento "Uponor Combi port PRO"
Buonasera, come da oggetto abito in un appartamento (sito in un condominio, nuova costruzione standard Casa Clima "A") con caldaia centralizzata e riscaldamento a pavimento. All'interno del mio appartamento, l'apparato che controlla e gestisce il riscaldamento a pavimento (e acqua calda sanitaria) è il 'Combi Port PRO'…
-
More than one PV array
Hi, The ability to add your Solar Array details to your Tado Balance system was launched a few days ago. Sadly, it doesn't give any way to add more than one array, and I assume most of us have solar panels on more than one area. In my case it's South-West, North-Eas and South East with different angles and numbers of…
-
More detail on device errors - Wireless Receiver
Quite often the Wireless Receiver is showing 'device errors' (blinking hazard light) but none of the devices actually have any issue. I believe that this condition is also explained by the fact that a software update may be in progress. However, this is not at all obvious. It would be really good if there was an option to…
-
Hot water tank thermostat
Is it possible to connect a temperature sensor/thermostat on a hot water storage tank to tado? I have a gravity fed hot water system, with a hot water storage tank. When the central heating is switched off, but hot water is on, the boiler is switched on & off by the boiler thermostat. As the hot water is heated by…
-
How to link tado to ovo
Hi all I just brought a tado and want to link to my OVO account but haven't been able to find out how. Can anyone help? thanks
-
Can’t turn off thermostats
Hi, I have three smart radiator thermostats installed and they worked very well all winter long. Now it’s spring and the temperatures are high, so I want to turn off my thermostats but I can’t. I select turn off all rooms in the app and they do turn off, but a few hours later they’re back on by themselves. The room…
-
remove heaters for paintings
I had to remove the heaters because of painting. To continue to use hot water was necessary to close valves on wall heater connections; for the outgoing valve was not a problem because it is totally mechanical but for the incoming valve, the one controlle by tado smart valve, it is not available an option to only close the…
-
Controlling a Thermix plinth heater
Is it possible to control a Thermix plinth heater with a Tado Smart Thermostat? The plinth heater runs off the central heater water supply and is controlled by a thermostat - very similar to underfloor heating. https://thermix.co.uk/plinth-heaters/kph2100w/
-
Inputting heating bill for oil kerosene top up.
Is it sensible to firstly input the previous year's oil consumption and average price before we input the last heating bill. Do we use units ie is a unit a litre. Oil is 10kw/litre or is a unit a kw? What's anyone else doing? I have asked via the bot but not got an answer yet.
-
IQ for oil
Can we have some way of logging to price and amount of oil when tank.gets filled. I suspect you can't get it accurate but some idea is better then none. The energy IQ is useless to us oil customers, there I'm sure many out there that use oil.
-
Oil consumption energy IQ
Hi, Anyone has good workaround on hot to calculate heating costs with oil heating? The best I came up is to say 1 litre oil gives 10kwh and cost of 1kwh is cost of the 1 litre divided by 10. Not sure will this correctly calculate cost yet to see. Any other ideas?
-
Adding an electric radiator
Is there any way of adding a room with electric radiator to the Tado system?
-
Smart AC Thermostat Battery Pack & Homekit Upgrade
Hello folks! I'm a tado enthusiast and I built quite an ecosystem at home: always felt that tado products have an extra kick both in design and experience customization which made me choose them above the competitors. I was a bit turned off by the Smart AC Thermostat USB cable hanging along the wall and plugged in the…
-
No bill from Tado - What to do?
I don't get an invoice for the yearly tado assist with German VAT from tado - I do not find it when I do logging in my tado account. What we do now is we write a replacement invoice from the Tado GmbH, Sapporobogen 6, 880637 Munich, Germany with VAT-ID DE280245443. This i how I book it and claim the 19% VAT from the German…
-
Need to add an additional Heating Unit in the Energy IQ feature (Cubit Feet) for the UK
I'd like to request that the Tado Development team add an Heating Unit of Cubic Feet (ft3) in the Energy IQ part of the app. At the moment, there is only m3 (cubic metres) and Kwh there at the moment, and a huge number (Millions) of UK homes have gas meters with cubic feet callibration not m3 or kwh. Without having Cubic…
-
Develop a "basic backup schedule" mode for when Tado outage or loss of internet
tado EDIT 10.02.2021: Please read my statement on this topic here: https://community.tado.com/en-gb/discussion/comment/22789/#Comment_22789 Original post: When Tado devices lose access to the Tado servers, either due to a Tado server outage (as has occured a few times), or due to temporary internet issues at the property,…
-
Plot all rooms on same graph
Perhaps with selectors to show/hide rooms. Would be great to see the interaction between temperatures!
-
UK users - Would you like to have Cubit Feet unit available in the Energy IQ feature?
I received an email from Tado today which stated " "Our team is now actively monitoring the forum to ensure an engaging experience for all members". That made me realise that people's previous requests for enhancements were probably never seen by anyone from Tado! Hence the creation of this poll. Personally I'd like to…
-
Ideal Logic+ Combi (pre 2014) not working as intended
Hi all, I've recently moved into a property that has an Ideal Logic+ Combi 30 boiler (one with the smaller LCD screen - see image). It currently only has a Mechanical 24hr timer installed in the front face. I have attempted to install my Tado extension kit but it doesn't seem to fire the boiler or stop it from firing. As…
-
Tado Smart AC V3 and HomeKit - only off/cool, no way to set heat mode
The title tells it all: I can only turn off and set AC to Cool mode, but not Heat mode in Apple Home. In Tado own app I can set all modes. What am I doing wrong? Thanks!
-
Controlling heat pump for heating and cooling
By now more and more owners adopt air-water heat pumps to heat and cool their houses by water plumbing under the pavement, so saving energy respect to other solution. What is of paramount importance given the present surge of energy prices. Yet so far Tado has no solution for this configuration, notwithstanding it would…
-
Wireless Receiver with Wireless Temperature Sensor?
Hi, Can I have a Tado system with a Wireless Receiver, without a Wireless Temperature Sensor, and with Smart Radiator valves?