My heating is always on!

Jbcook

I've come from a nest system. I've got an s plan system, with two 2 port valves. One for Hot water and one for heating.

I've wired the tado receiver as instructed but now my heating is permanently on. There's no heating light on the reciever and the heating shows as off in the app.

If I turn the heating on in the app, the light appears on the reciever though there is no "click" heard.

Hot water all works as expected.

I was advised to swap the cable from CHNO to P1 which I did, but that resulted in no heating whatsoever.

Appreciate any help. Support are being achingly slow and I've been trying for 5 days now.

Frenchie

This is happening to mine also and the only way to get the heating off is to switch the boiler off at the mains

davidlyall

What exactly do you have in your tado system? Extension kit, smart thermostat and TRVs?

Could be a stuck relay as mine has done that a couple of times in two years. Powering off fully and back on fixed it for me.

Could also be that your smart thermostat is set up to allow TRVs to call for heat in which case, it's relay is always closed and the heating switching is fine by the extension kit but then you'd be able to hear the relay click when you turn on heating

Alper

I have the same problem here. I have replaced a Honeywell wireless receiver with tado and now my heating is permanently on. Even when the thermostat switches heating off, there is no difference. I have checked the NO connection on the receiver and it is live no matter what state the heating is in. The valve is always fed current no matter what I do. Please advise.

Nickens

Did you manage to get a resolution? I’m interested as have the same situation really.

housekeeper

Same issue. Initially on app was showing “heating to” on radiator thermostat, reinstalling it changed text to “set to”, but issue with constant heating is still present. Support washed their hands saying it is boiler issue, however electrician who looked at it earlier said that wire connected to boilers burner is always live, meaning extension box was constantly sending signal. Looked on other forums it seem like a common issue. Would be nice if Tado will look into it.
Currently have to switch heating off manually every time it’s warm enough. Returning Tado devices

Ratomir

Same problem here... If I don't find solution I would say that Tado is not good solution apart from valves

MarkJordan088

Same here, system was working fine for months and then all of a sudden it's alway on even if it is schedule to be off or has hit the set temperature.

The app says the heating is off and I can see the boiler running, the wireless receiver light is also showing as "off" but the boiler is running at full blast.

PAS123

I have just installed a tado system and I have the same problem but mine is with the hot water rather than the heating. The app and and controller both indicate that the hot water is off but the boiler is still running and pumping hot water into to my tank

Scotster

Im on my third extender after 6 years.

The 1st two had a stuck relay sending HW command (240v) to the boiler constantly. Luckily I can usually pick up a used extender on ebay for cheap.

How do I know? You will need a multimeter and very basic understanding of how your extender works..its not difficult.....Live voltage warning! :-)

TenInchTony

Have had exactly this problem with a new install over the last few days. After reading this, took the handle end of a screwdriver, a few solid taps left to right and back again, le voilà.
I'm going to ask Tado to send me a new controller unit under warranty.