-
Why does Thermostat not use boiler fully?
If I manually boost my heating for an hour, the target temperature is rarely achieved, but the boiler isn't asked for full capacity ie 1 or 2 bars only. Why?
-
Heating Not Coming On
Hi Had a new boiler fitted yesterday (Worcester Bosch Greenstar i). This was fitted with the Tado Themorstat and extension kit. Internet bridge has 3 lights on, thermostat is paired (the chain links on the display are joined together) and the extension kit light is "breathing". Yet when we turn the thermostat temperature…
-
Do i need smart rad thermostats in the room with the smart thermostat
I have the smart thermostat in my livingroom with 2 radiators. Do i need to equip both radiators with smart rad thermo valves or can i just put open/close valves on them and let the smart thermostat regulate the livingroom temperature?
-
Upgrading from Honeywell AQ6000 controller to Starter kit V3
Hi I have purchased the starter kit v3 and I'm beginning to wonder if it is not compatible with my current system or requires additional parts/modifications (or that most of the sensors wiring isn't required for a Tado installation). Boiler is a Potterton Precision condensing boiler. Currently wired using L,N and E. No…
-
Setting up new system without Internet
My friend is buying a house and moving in on Friday. She will have no internet till late next week. The system in place has been left by previous owner and is a standard smart thermostat and internet bridge, with I think a wired boiler reciever. I have a Tado system in my own house so I know how it works in general. But…
-
Tado Extension Kit to replace Nest V3 (Heat link) ?
Hi, I currently have a Nest V3 thermostat with the Heatlink connected to a combi boiler in the UK. I'm thinking about replacing it with a Tado thermostat and Extension kit after using the radiator valves. Has anyone done this, and if so, was it a straight swap (take out heatlink, install extension kit with simple wiring…
-
Extension kit
I have just bought the full Tado system which I thought was wireless, but it appears the Extension kit needs to be wired to the boiler! I currently have a ideal logic +35 combi boiler in the kitchen with a wireless thermostat in the hallway. No wires go into the boiler or around the house. So assumed the boiler already had…
-
Extension kit and smart thermosta supported power
Hi All, Im installing a thermostat with extension kit. the extension has to switch on the boiler as usual. I need also to power on two water pump circulator ( 220v, 50 Watt ). I would power on one pump with the same extension module and one with the thermostat. can i use the internal switch? can it bear this 220v load or i…
-
Re : Thermostat - programmation intelligente
-
TRV's with multiple heating circuits
Hey all, i have raised a ticket with support but while waiting for an answer I wanted to ask here for help. I have two heating circuits in my house, essentially one for downstairs an one for upstairs. Yesterday I installed Smart Rad Valves throughout the property - the issue I've notice is that when an upstairs TRV call…
-
E0 Error - V3 Thermostat to Internet Bridge
Hi guys, Apologies, but I've tried with Tado Support, but I'm not getting much help. I have a V3 Smart Thermostats and Internet Bridge, as well as multiple radiator TRVs. I have connected the radiator TRVs no problem, but the Thermostat is being problematic. When I turn it on and attempt to pair it (push button for 3…
-
Tado on Volt Free S Plan system
I have just picked up the Tado V3 Kit (Wireless stat, plus hot water controller) in prime day deals, though before I go crazy I have some questions. The installation manual cannot help me as says "not compatible" as I have the Scottish power connect, HOWEVER, The Scottish power connect is no different to many other…
-
Hearing thermostats working while it's turned off
Sometimes (usually at the same time at 22pm) i hear all thermostats adjusting something, making noise, but they're turned off - why is it happening?
-
No heating downstairs
Hi. Just moved into a home with Tado. 2x wired thermostat, one bridge, one extension. Boiler is potterton, not combi we have a tank. When we moved in no internet bridge. Tado gave us a workaround. Heating upstairs was fine intermittent downstairs. Bought a new bridge, all installed and connected. App can control all zones…
-
Installing Tado this weekend. Could experts comment if connections/wiring looks okay?
I have a combi boiler with wireless controller and relay(sitting in garage). I am planning to fit Tado extension kit and replace Honeywell relay this weekend and wanted to check if i got everything right.
-
How to get a TRV to work when I have 2 Zones
Hi I have 2 zones controlling my heating which is wired and to a combi boiler. All works correctly. I have just bought a Radiator thermostat valve and I have registered it and it talks to the wireless bridge so I have control of this. When I adjust the heat for the radiator valve the boiler is not switching on. I can only…
-
Question: replace or integrate Heatmiser UFH??
Hi all, I have two circuits on my heating system. An old Heatmiser system that controls the under floor heating on the ground floor (8 zone with a UH1 valve http://www.thermsaver.co.uk/wp-content/uploads/2015/07/Heatmiser-UH1-Wiring-Centre.pdf) and a Honeywell CM927 wireless thermostat that controls the radiators for the…
-
Established Tado Set Up - More than radiator no coming on when set to off
Have had Tado for a few years now, works really well except did get one radiator last year mysteriously coming on even when set to off ( one of three in a single zone, rest stayed off). Tado did remote diagnostic after I raised a ticket and I could hear the mortised pin going up and down to re calibrate under remote…
-
V3+ Ac control
Hi I'm using a V3+ to control my air to air heatpump in my summer house. I do the job very well, but I can't figure out why it shut down the AC down when it reach the setpoint on the tado. I don't want this function, so where do I disable it?
-
Combi boiler does not turn on after tado
Hello all, My husband just installed tado and after the combi boiler is not working and what should we do?? Does anyone have a tip?
-
Im so confused as to what i need
I'm moving into my new house next week but looking to purchase Tado in the prime day deal whilst i can. I have a 2 zone boiler/tank solution with hot water that i am looking to control with Tado. So i'm pretty sure im safe in saying the i need the wireless starter kit which will give me the the wireless receiver for the…
-
Combi boiler does not turn on after tado
Hello all, My husband just installed tado and after the combi boiler is not working and what should we do?? Does anyone have a tip?
-
How do I cancel a partially completed install and start again with different instructions.
I believe I have downloaded the tailored instructions for a different Worcester Greenstar 30si and not the version of the Worcester Greenstar 30si that I have. There are a plethora to choose from. How do I abandon the partially completed extension kit installation, download alternative instructions, and start again?
-
Versions of Tado that support Smart Radiator Thermostats
Hello. How do I find out if my version of Tado support smart Radiator Thremostats. I want to control individual radiators with the smart thermostats but concious that they may not work with the older versions of the hub (I've have my Tado for about 8 or 9 years now)?
-
What do i need to buy? SO confused like others. A total noob
Hi, I have combi boiler with Honeywell controller in hallway which i think talks to a square box next to boiler. It also says Honeywell on it. There is no way to confirm if these two are related. It could be my lack of experience. Any suggestions? on what do i need to buy? Just a smart thermostat or a Wireless Smart…
-
Do your TRV "calibrate" when you change the offset?
Hello, all of my TRV make the calibration noise (as if they were opening and closing the valve) every time I update the temperature offset Does anyone have any idea why this happen?
-
Is it possible to have more than 3 blocks in the Smart Schedule?
So far, I see that there are: one block which starts at 0:00, with no chance of modifying its start time one block which ends at 0:00, with no chance of modifying its end time one block which is in between and can be adjusted flexibly. Is it then possible to have 4 or more blocks in a day?
-
Confused don`t know what exactly I need
I live in a 3 bedroom 3 floors house, and I have a combi boiler installed. There is only 1 thermostat installed in ground floor, and 8 radiators all around. I want to install radiator thermostat on all radiators for this if I buy 8 radiator valves and the smart radiator thermostat starter kit V3+ is it enough or do i need…
-
Smart TRV operation
Hi all. Just had tado fitted thoughtout and seems when I call for heat in one room bed 1, I get heat in another room, bed 2. Even though bed 2 in set to off?? What does this mean? Thanks
-
tado° Wireless Temperature Sensor & Extension kit without Smart Thermometer
anyone using a tado° Wireless Temperature Sensor & Extension kit without the Smart Thermometer? i have a starter kit that came with the bridge and 2 x trv's. i have just ordered 8 x additional trv's & am hoping to save some money by purchasing the Wireless Temperature Sensor & Extension kit for ~£98 instead of the smart…