-
Extension box (hot water) stopped working since yesterdays application update
Hi, I've logged this with Tado but wanted to ask the question here in case anyone else is having similar issues. This morning we woke up to no hot water, our set up is relatively straight forwards - usual heating (which is working great) and an Extension Kit that is used to switch the hot water on/off. What I've found is…
-
Pointless zone thermostat
I have a two zone home. One zones smart thermostat is in a ground floor hall way which works ok. The second zones smart thermostat is in the main bedroom with a free flow radiator. I want to put a smart TRV on the radiator and just use the wired smart thermostat to drive the zone switching. Do I need an open flow radiator…
-
CH & HW Switching Stopped
Interesting experience this week when I was without heating or hot water for a day or so. The app was commanding both the CH and HW to be ON, however the Extension Kit did not appear to be switching on the boiler. Reset the Extension Kit, Bridge and my router, but still nothing. Tado support did the same, except for my…
-
New WIFI hub doesn't have USB for bridge
Would appreciate help with how I get around this. I changed my WIFI hub and the new one doesn't have a USB port. I am advised that they do not have them now. Has anyone else had this problem and can advise please? Thanks
-
Set up issues about to lead to nervous breakdown
My smart thermostat is connected to the bridge and they are connected to the Internet. However the extension kit will not connect to the rest of the system. The electrician and the plumber who have been working on renovating the house insist its wired properly but it appears dead. They are ready to quit the project citing…
-
Tado AC compatibility check
Does Tado AC controller only support AC units with infrared controls? Would it work with Fujitsu ASYG12KMTA I have attached their brochure. Thanks in advance
-
Smart AC v3+ Fujitsu asyg12kmcc problems
Hey, I got a tado yesterday and cannot get it to command my AC unit, when setting up the AC responds to commands but as soon as the setup is over it’s impossible to turn it on using Tado.. Has anyone faced a similar situation ? I’ve tried running through setup about 10times, did a factory reset.. Kinda out of ideas.
-
Tado Stats - Timeline Graph
Hi, On the iPhone app you have the ability to see a timeline graph for each room and what Tado is doing, temps etc. I find this a bit too small due to screen size. Is there anyway to see these timeline visuals on the web app? I've looked everywhere in my Tado account and cannot find anything obvious. If not, is there any…
-
The LED on my extension kit is off, and the device is offline
Hi, The LED light on the extension kit is off. The is on, and the device is offline in the api. Does this mean for what ever reason the extension kit is just broken? Many thanks
-
Why Tado?
Ive recently installed a full Tado system inc. hot water. I am now regreting doing this. Instead of making life easier, and lowering my heating costs it seems to have done the opposite. Pre Tado, when I came home from work I dcould flcik one switch and the heating would come on, the whole house yes, but just one switch. If…
-
Unsolvable motorised valve problem
Tado technical don't know how to do this so I'm hoping somebody/anybody here can offer some guidance. I'm trying to control a normally-closed 5-wire motorised valve (see link below) with a Tado thermostat. I spoke to Tado technical and they said "wire the grey to NO and orange to COM". I did that but as soon a power is…
-
Can I replace my wired thermostat with a wireless thermostat (with the extension kit)
I have an ancient Honeywell 4200 thermostat and the wiring was never chased into the wall. With Tado and the extension kit do I need to keep the wiring and wire in the smart thermostat or can I use the smart thermostat in wireless mode as a replacement for the wired thermostat? Thanks 😀
-
Best way to setup TADO in my system
Hi, My current heating system has underfloor heating and radiators (near the windows) but only one thermostat in the living room that controls heating through the entire house (two floors). I wonder if it would be possible to setup TADO to control the room's temperature independently as possible.
-
Heating coming on but no request for heat.
It’s summer every room is at least 1 degree above the set temp, but every night around 22:30 the heating comes on. No rooms are calling for heat. What is going on?
-
Heating coming on but no request for heat.
It’s summer every room is at least 1 degree above the set temp, but every night around 22:30 the heating comes on. No rooms are calling for heat. What is going on?
-
Installing Tado over a Potterton 5100583 PRT100ST2 thermostat
Hi I am attempting to self install my Tado thermostat. Having removed the cover I am presented with the following S(see attached screenshot). The Tado guide says label the wires and connect wire 2, 1 and 4. On my unit I have no wire in terminal 1. Any help would be welcomed. Thanks
-
Glow-worm Easicom 24 boiler constantly on
I've recently installed a tado thermostat, two tado TRVs and an extension kit to replace my old BDR91 thermostat. The old thermostat was wireless and talking to a BDR91 receiver, wired to the boiler. I followed the tailored instructions sent by tado. Wiring seems correct, as confirmed by the tado support team. My boiler,…
-
wifi brodge
hello' the wifi bridge is not listed in the APP- cant install it
-
Changing stat names
How do you change the stats in the tado app to the rooms they are in ? mine still have the RU number and not named just added two new smart thermostats
-
EBUS configuration
Hi, I will buy a Saunier Duval ISOMAX (Vaillant group) with ebus and I have a Tado v3. Could you give how can I settings my setup? Thank you.
-
Underfloor heating installation
Hi guys, struggling to find information on what exactly i need for this so thought i would ask here... Just having extension works carried out at home, and want to convert the heating in living room to wet underfloor heating (single room kit only). The living room has a smart stat and a smart radiator stat fitted. The rest…
-
Multiple thermostats needed?
Hi, I've purchased various components in order to set up my house using your system. I have several (10+) Smart Radiator Thermostats, a Smart Thermostat, an Extension Kit, and an Internet Bridge. One room in the house is a separate dwelling. Someone lives in there who does not have access to the rest of the house. We do,…
-
Heating is on with hot water
Hi there, I have my vaillant gas boiler repaired yesterday, and after that I found the heating system is on/off with the hot water, even the heating is turned off. The gas boiler is seems working fine so the engineer ask me to investigate the control system. The tado control was working well before the boiler repair. What…
-
Tado controlling hot water but not heating - Easicom 24 boiler
I've recently installed a Tado system on my Glow-worm Easicom 24 boiler. I am now able to control the hot water via the thermostat and the app (e.g. turn it off, or adjust temperature). However, the heating never turns on regardless what temperature is set on the thermostat. I've tried switching it to very high, and…
-
Smart termostat does not recognize må AC
I have an Mitsubishi MSZ-AP25VG but the setup keeps saying it does not find my system, is there a Way to ADD it manually?
-
Multiple Smart Thermostat one for each room - essential ?
Hello, i have recently bought and installed the tado heating system (starter kit) - it contained a smart thermostat that i installed in one room (passage) and multiple smart radiator valves which i installed in other rooms (living and bedroom) Please note that the radiator in the room where the smart thermostat is placed…
-
2 zones, Upstairs zone heating staying on all the time
Hi I have two zones, downstairs and upstairs. Each zone has within it, several smart radiator thermostats. The upstairs zone reads at a low temp but all the radiators are on full and the smart radiator thermostats read the temp on the main smart thermostat (16 degrees) when they are obviously not. I presumed the main…
-
If I replace the controller can I keep manual thermostat ?
My first Tado thermostat is working fine. I'm thinking about replacing the controller with the Tado extension kit so I can operate the hot water but I still have one other original manual thermostat. Will that old thermostat still work once the controller has been replaced by Tado? thanks in advance Ian
-
my thermastat will not link to the bridge
my smart thermostat will not link to my bridge
-
tado turning heating off without being told to by user
setup: tado smart thermostat, tado Bridge, wired direct to boiler I've had tado for a few years now and nothing has changed with the setup. Until recently tado has worked perfectly, turning on/off heating correctly. However over the last few days the heating hasn't been coming on. On checking the tado app tado says the…