Anyone fit an extension kit to ideal logic heat H15 ?

nytram

Been sent the wrong instructions and awaiting new ones....i hope.

I dont some one has any for the boiler ?

Thanks

Martyn

[Deleted User]

Hello nytram,

We have seen that you have since contacted our Support Team,

For any further questions, please do not hesitate to contact us.

Kind regards,

Joey

tadcad01

Hi nytram, I fitted the extension box to an ideal h15 boiler. Hardest part was getting 4 earth wires connected. Didn't seem enough space. What programmer do you have? I had Danfoss TP9000 programmer with TS2 sensor in hall. L, N, 3 & 4 with 5 &6 disconnected and stowed as went to heat sensor in hallway.

nytram

Hi.

We had a danfoss tpone -M which did water and heating and -B that was just a thermostat.

Do you have the instructions as i currently have the extension kit on the wall instead of the -m

Id ideally like to put the extension kit in the airing cupboard with the boiler. Did you wire it in to the danfoss wb12 connector ?

Then i can put my extra thermostat on the wall.

Thanks

nytram

Also did you do anything with opentherm to get the water temperature ?

Yusuf

Hey @nytram i have the exact same setup as you in terms of Danfoss + Ideal. Did you ever get it setup how you wanted?