-
Different colour radiator thermostats
We have raw metal radiators and the white radiator thermostat valves look out of place - I may try painting them but think would be a nice idea if Tado offered black and grey etc… as opposed to just white?
-
Using Neometris thermostat wiring
I am hoping someone can help me. I have purchased Tado V3+ to replace my existing wireless thermostat - Neometris. I am hoping I could just use the existing wiring however I cannot work out which wires go to which port in the tado receiver. In the Neometris I have 2 blue wires going to N and 2 brown wires going to L which…
-
App not showing correct schedule on home page
Just wondering is anyone else tado not following schedule? I have tado and all my radiator setup. However my schedule is set up to be on for 2 hour at 19c at 6 to 8am then drop to 17c until night. It should be set to 19c at moment but all my room are saying current schedule is 15.7c Has something changed with tado is it…
-
27 degrees in winter. Heating won't turn off!
We have 2 bedrooms with Smart Radiator TRVs and the Wiresless reciever+Wireless thermostat connected directly to our Zone Valve+UFH downstairs. Everything was working fine a little while ago but now the upstairs TRVs are switching on the UFH and heating the downstairs uncontrollably. The Wireless thermostat downstairs will…
-
Using Neometris wireless thermostat wires
I am hoping someone can help me. I have purchased Tado V3+ to replace my existing wireless thermostat - Neometris. I am hoping I could just use the existing wiring however I cannot work out which wires go to which port in the tado receiver. In the Neometris I have 2 blue wires going to N and 2 brown wires going to L which…
-
Bridge - reboot from a PC on the local network
I have an issue with my bridge. When we have a power out, which happens 5/6 times a month, the bridge powers up before my internet re-connects. The bridge then fails to connect to the internet. A reboot of the bridge with a good internet connection fixes the issue. But that is no good if I am away from home. if I know the…
-
Some valves have started “whistling”
A few of my TADO valves have started whistling. I’m pretty sure the issue is that the valve isn’t 100% closed and the sound is cause by water rushing though the slightly open valve. We have had the valves for about a year and a bit so it’s not a installation issue (they didn’t whistle before). I have tried recalibrating…
-
Quiet fan mode - AC units
Using the setup guide, and referencing the model of Mitsubishi Electric AC units that I have, it supported a lot of the modes that are possible. One omission that I would like to have added is the "quiet fan mode". We have a unit in the bedroom that we use every night and with the IR remote that came with the unit you can…
-
Smart TPV in one room shows higher temperature
Hi all. I am newbie here. i just got tado system a few weeks ago and something interesting is happening in just one room. Our setup: 3 zones. 1 hot water and 1 main area. 1 master bedroom. Wireless receiver + thermostats v3 One wired thermostat 8 smart TPVs Each room has smart tpv. But one room is misbehaving. We call it…
-
Which System?
Hi, We've moved into our new build home about 10 months ago and are now thinking about installing a Tado system but I'm not sure which I require. At the minute we have a Valliant ecoTEC sustain 28 VUH 286/7-2 combo boiler and a hot water tank which I'm looking to control. We have a hard wired thermostat located in our…
-
Apple Watch App
I've got quite a large Tado heating system installed on everything in my home. I've just got an Apple Watch. I get the notification when I leave home on the watch. However, I can't switch to away mode from the watch. This would be very useful (and also to be able to switch back to home mode). You definitely need to write…
-
Tado app for Apple Watch or other watch
It’ll be cool, we had an app for the watch for using on Apple Watch or other Stead of using the HomeKit it will be better than he had an app for the watch is the same way as the iPhone and iPad Don’t want to use HomeKit Can you make one please?
-
My Android App asks me to login everytime
Is anyone else having issue with having to log on everytime you load the Tado App in Android?. It's very annoying and appears to have started only this week
-
Could use some help to gain efficiency (35%)
Good evening all I am seeking some of the help to get my setup right. I got Ideal Vogue 32 Max in my 3-bedroom house. I run it with a total of 11 radiators. My heat loss calculation seems to be (if I have done it right) at about 6.7kW. I got Tado Wireless kit (EU version) and it is plugged in and configured for OT. I do…
-
Zigbee Thermostat
One question, can the Tado controller connect to Zigbee 3.0 Thermostats?
-
Thermostat direction
Hi, I think I may have installed some rad thermostats as vertical stats and not horizontal, anyone know how to check in the app?
-
Existing Tado Installation - now suddenly Heating not working?
Hi All, My set up is a Vaillant EcoTEC Plus 424 Boiler (Water tank in attic and cylinder in airing cupboard). Gravity Fed system. I installed a wired receiver (below boiler), wireless thermostat (in hallway) and 10 x smart TRV's (note: i also have approx. 6 non smart TRV's on other rads in the house). I installed all this…
-
Heating off but TADO sending constant "Switch Live" to boiler
Summertime, so heating off, but my boiler constantly running and bathroom radiator always warm. I have a Baxi DuoTec combi boiler, starter kit, plus 8 Smart Rad valves on all rooms except bathroom - which is set to on/open. Recently, my boiler pump has started running constantly, with the boiler firing up periodically.…
-
Modulation with Multi Zone
I am looking to purchase a Valliant Ecotec 938 or Veissman 111-w. This will drive 1 zone of radiators and 2 UFH zones (via 2 port valve). I am thinking to go for the Tado 3 Wireless EU version to modulate the radiator zone via eBus/OpenTherm. I assume I would need 2 wired thermostats for the 2 UFH zones. Would the wired…
-
Verhalten bei temporär abgestellter Heizung
Hallo, morgen wird bei uns zwischen 09:00 und 16:00 Uhr die Heizung aufgrund von Wartungsarbeiten abgestellt. Muss ich die Thermostate ausschalten, damit die nicht krampfhaft versuchen hoch zu heizen? Grüße HagenB
-
Incident detection did not work in Care&Protect
Hello I’m new to Tado community (just bought my first starter kit this month), so I might miss answers on this topic. Some days ago, I was away from home and set the Tado on Off mode. In the day of my return, I remotly set the Tado to Auto scheduling, to start heating the house for the time I’ll arrive. The problem was…
-
Do i need to replace EPH controller in order to use Wireless Thermostat.
Firstly, VERY HAPPY to have found this community, google wasn't helping much. I currently have EPH 37HW (3 channels) 1 Upstairs 2 Downstairs 3 HW. I do not use the HW zone as i have a seperate timer on my roof hot water system. My 2 current thermostats are next to the back door and in an upstairs hall way, neither are…
-
Whistling tado
Now and then, mostly early mornings and late evenings, after the temperature is set to change, one of my Tado whistles loud and the other softly. Another three do not whistle at all. If I press the Tado round front piece inwards, the whistling pauses, then resumes when I let go. I have a video of this but I am not sure how…
-
Cooling for underfloor water systems
I have "centralized" machine for deliver heating or cooling (according to what it is configured by building manager). I am asking to include some kind of software switch to change between winter and summer mode, just to be able to manage cooling underfloor water system (set 25ºC temperature as a target and achieve it while…
-
Add imperial units to measurement options in EnergyIQ
Older style meters (pre-smart meters) still provide meter readings in imperial units - cubic feet. This means customers without smart meters cannot use the EnergyIQ, because it only allows you to add meter readings in cubic meters (new style meters).
-
How do I diagnose errors indicated by “device error” light?
I woke this morning to find Tado’s call for heat had not been answered by the boiler. On the wireless receiver, both the wireless and device error lights were blinking. Nothing was reported (eg device disconnection) on the app. I ended up having to turn the boiler off and on in order to fix the error. What more could I…
-
Duration for manual control through thermostat
I would like to set, using the app, the duration of the manual temperature control activated through a thermostat. I would like to choose between until you cancel until you resume schedule until the next time block Right now, there is no choice and "until you cancel" is the only behaviour.
-
Some Radiator Thermostats not responding to geofencing Away
I have 8 rooms set up with Tado radiator stats. When I click Geofencing away, 3 rooms do not respond. Do I have to set up those room stats again?
-
Responsive User Interface
The User Interface should be responsive to ensure it renders correctly on all screen sizes maximising the resolution to ensure the best possible usability. When programming complex schedules it's much easier to use the web interface on a PC or Mac where you should have the benefit of a large screen showing the full smart…
-
Random app log out
Does anyone else randomly get logged out of the Tado app? Seems to happen to me quite often ; got to open it and then need to resign in and reclaim device etc. Is this just a security thing in the app or is it an issue with the app itself (or maybe my phone?!)