-
Extend programme by a set time.
I want to be able to extend a running programme by a chosen time, (say an hour), if the weather is cold. I don’t want to “boost” but just ensure that the programmed “off” time is delayed. I can do this by modifying each room, but this is just a waste of time.. is there any way of doing this with a single button. It seems…
-
When setting ‘Away’ mode one of the four rooms ignores the request
No matter what I do the away mode completely ignores one of my rooms.
-
TRV adapter not quite right?
Installed two TRvs today for first time and odd issue. Both are up and running but at a lean :/ One of the adapters screwed on ok but then ended up at an angle… so not the whole trv is at an angle. But they are working. The thread on the adapter and the radiator pipe match so I’m confused!
-
Geofencing
I just bought autoassist. However I put on geofencing. My partner and I went out. But the thermostat did not go off . On thermostat have away mode switched to frost protection . Any ideas.
-
Bathroom towel rail
How do I attach a smart trv to this bathroom rail
-
Question about TRV temporary offline
I am in trouble, so I ask this question to be sure. Randomly my TRVs notify battery problems or go offline, but after (max) a couple of hours are again OK. Assume a TRV is offline at the moment something is happening such as a change in the scheduling, from ON to OFF or OFF to ON. What is going to happen once the TRV goes…
-
installed tado as per instruction but boiler keeps switching on
Dear Tado team, i installed the Tado wireless heating and hot water unit today and having issues with the programmer. i had the Drayton programmer and i managed to install the wireless temperature sensor and wireless programmer. However the boiler keeps coming on even though i have disconnected the old wired thermostat.…
-
OpenTherm advantages? Should I get the EU thermostat?
Hi All, I have a Valliant ecoTEC pro 28 R2. I have just purchased the following: Starter Kit - Wireless Smart Thermostat [incl. Programmer with Hot Water Control] (V3+) [UK] EAN: 4260328611807 Add-on - Smart Radiator Thermostat - Quattro Pack [ML] EAN: 4260328611845 As I understand it the UK thermostat does not support…
-
Replace Danfloss setup with Tado
Hi, I've a Danfloss CP/FP715 along with two manual thermostats. The Amazon deal of the day is this: Deal of the day: tado° Wireless Smart Thermostat Starter Kit V3+ Incl. Stand – Full Control Over Your Boiler And Hot Water From Anywhere, Save Energy, Easy DIY Installation - Works With Amazon Alexa, Siri, and Google…
-
Suggestion for TADO Bods
When viewing any room screen the little flames show 1,2 or 3 depending on how wide the Smart rad valves have opened giving some idea of the individual flow rate. Now it's OK to check each room to see how many of any flame icons are showing. However with 'Care and Protect' being able to show how many hours the boiler was…
-
Issue with geofencing
It seems there is a bug with geofencing. My app correctly detects that I’m away. All rooms controlled by thermostatic valve are controlling temp based on away setting. However the room controlled by a wireless thermostat keeps using the home schedule.
-
tado short cycles my boiler, and it's getting on my goat
Hi folks. I have a fairly simple system - a single tado thermostat, hooked up to a Grant condensing oil boiler. No rad stats, no multizone, no nothing. This system works great, but tado is doing something wrong. Example: I've been out all day so the Away temp has dropped to 17C. I come home, tado recognises this and…
-
Tado Cloud down?
All my devices lost their connection at 12:58 pm on 17 Jan 2024. The apps on my iPad and iPhone are unable to connect to the cloud. I cannot control anything from my online account because none of the system is connected to anything.
-
Explain the heating graph
Hi I woke up this morning with the bypass rad on checked and assumed it was frost protection kicking in, I always assumed if one had frost protection turning on then they all would turn on, so anyway I assume the blue arrows are heating times but what is the red arrow pointing to ? Thanks
-
Central Heating System not coming on in morning......
Hi All, Strange one really, but the Central Heating doesn't kick in in the morning when it should... I have found that when I check the App, this seems to start the Central Heating...(?!) For example, today heating was supposed to come on at 07:00hrs , checked but not on at 07:25, but then came on within a minute or so of…
-
Not working from abroad
My Tado works perfectly fine in the UK. I am now abroad for three weeks and I am unable to control my heating. Any ideas?
-
Disable Opentherm?
Hi, is it possible to disable Opentherm (modulation) once Tado is physically installed. Is there a menu in the thermostat that allows for more relay on/off? It's -5 right now and flow temperature is going from 46 to 60c and I want the radiators to take 70c for the morning (couple of hours).
-
Thermostat Sensor not working
Hello, Does TADo have a phone number in UK ? My smart thermostat sensor is not working (I had the smart TADO installed last week). I talked with someone in the chat and they told me that they will open a case as everything tried on the sensor did not work. I had a professional install the thermostat after receiving a…
-
My app keeps saying “open window detected” but all windows are closed
Hi all My app started to send me notifications about open window detections but there is no windows open. It has been a very cold night in Denmark and the thermostat is close to a large window, could that be the reason? Although, I also have another thermostat close to a big windows that does not say anything. I tried to…
-
TADO works as a Relay System or Modulating?
Hello, I have a Logic combi esp1 35 boiler which was controlled by a Danfoss tp5001 wired thermostat. The thermostat had only two wires, COM and NO. Its manual states it is an "On/Off load compensation thermostat". The boiler has a "Fully modulating operation to low outputs" (from the manual). The manuals state that both…
-
Tado to Worcester Bosch GreenStar 30i Digital Interface EMS Connection Bus (Working Setup Attached)
Hi below is a working setup for a Worcester Bosch GreenStar 30i Combi Boiler using the Digital Interface EMS Connection to a seperate wireless tado thermostat in another room I hope others find it useful Basically I removed my old Hive connection and receiver altogether from the boiler before i started on setting up Tado I…
-
Replacing Mechanical Timer + Thermostat
Hi I have a mechanical timer controlling both hot water and heating. I also have a wired thermostat for the heating. Images attached. Can I replace my current system with the Tado V3+ with Hot water control(or any other Tado thermostat ??). And can I do that on my own or I need an expert? Are there any instructions or…
-
Help! Wireless start kit v3+ installation
Please help! So sorry if this is silly but I am very confused and unsure if I have bought the wrong kit. I have a Worcester Greenstar CDi classic boiler and Digistat Optimiser and have bought the Tado wireless start kit with radiator valves. I have someone coming to fit for me but was looking through the box beforehand and…
-
Humidity smart action trigger
Is there a way to set trigger for when humidity is at the set level to send notification via Alexa or Google or any third party integration? Ideal would be to look at the humidity inside and compare to weather forecast humidity level and if outside is lower than inside send notification to Smart home devices or phone to…
-
Can an Extension Kit do a ZeroVolt link ?
Can the Extension Kit give a ZeroVolt Volt Free connection ? Basically, if a boiler needs two pins to be shorted out to fire the boiler, can the Extension kit do such a connection, or does it just send 230v down one link ?
-
Bye Bye tado
Well. tado is no longer in control of my heating. The final straw was someone in their support team pushing a new configuration that completely broke the system. Smart Thermostats: (both) constantly show Configuration Download icon. Internet Bridge: When powered up or reset, goes through the normal cycles, then ends with…
-
Anyone used this Opentherm Adaptor with the TADO Thermostat?
Hi, Im trying to convert my new Bosch Worcester 8000 Life to use Opentherm (or any modulating interface) with TADO. Nest users have pointed to this adaptor which converts the EMS in the boiler to Opentherm that can be read by a Nest V3. Just wondering if this also applies to TADO?
-
Heating still on when all TRVs off
Hi. Tado support recently updated my config so all TRVs have the extension kit as a zone controller. This was in response to a situation when a call to heat for one bedroom radiator would result in a lounge radiator also heating. I was told it was because the bedroom radiator had the wrong zone controller, which was a…
-
Setup question
Hi, just looking for some advice on a setup for a newly renovated house. im having a WB boiler with separate water tank. looking to control UFH with three zones then heating to std rads in the rest of the house(will add in tado trvs at some point) could someone advise what kit would be needed. thanks for the help
-
Radiator Thermostat not keeping target temperature
I just got a new wireless thermostat+ smart radiator valves for the different rooms. The issue is that the rooms heat up to the target temperature at the beginning of the schedule/ when turned on manually, but then fail to keep the target temperature. My flat is extremely poorly insulated, so the temperature drops markedly…