-
Established Tado Set Up - More than radiator no coming on when set to off
Have had Tado for a few years now, works really well except did get one radiator last year mysteriously coming on even when set to off ( one of three in a single zone, rest stayed off). Tado did remote diagnostic after I raised a ticket and I could hear the mortised pin going up and down to re calibrate under remote…
-
V3+ Ac control
Hi I'm using a V3+ to control my air to air heatpump in my summer house. I do the job very well, but I can't figure out why it shut down the AC down when it reach the setpoint on the tado. I don't want this function, so where do I disable it?
-
Combi boiler does not turn on after tado
Hello all, My husband just installed tado and after the combi boiler is not working and what should we do?? Does anyone have a tip?
-
Im so confused as to what i need
I'm moving into my new house next week but looking to purchase Tado in the prime day deal whilst i can. I have a 2 zone boiler/tank solution with hot water that i am looking to control with Tado. So i'm pretty sure im safe in saying the i need the wireless starter kit which will give me the the wireless receiver for the…
-
Combi boiler does not turn on after tado
Hello all, My husband just installed tado and after the combi boiler is not working and what should we do?? Does anyone have a tip?
-
How do I cancel a partially completed install and start again with different instructions.
I believe I have downloaded the tailored instructions for a different Worcester Greenstar 30si and not the version of the Worcester Greenstar 30si that I have. There are a plethora to choose from. How do I abandon the partially completed extension kit installation, download alternative instructions, and start again?
-
Versions of Tado that support Smart Radiator Thermostats
Hello. How do I find out if my version of Tado support smart Radiator Thremostats. I want to control individual radiators with the smart thermostats but concious that they may not work with the older versions of the hub (I've have my Tado for about 8 or 9 years now)?
-
What do i need to buy? SO confused like others. A total noob
Hi, I have combi boiler with Honeywell controller in hallway which i think talks to a square box next to boiler. It also says Honeywell on it. There is no way to confirm if these two are related. It could be my lack of experience. Any suggestions? on what do i need to buy? Just a smart thermostat or a Wireless Smart…
-
Do your TRV "calibrate" when you change the offset?
Hello, all of my TRV make the calibration noise (as if they were opening and closing the valve) every time I update the temperature offset Does anyone have any idea why this happen?
-
Is it possible to have more than 3 blocks in the Smart Schedule?
So far, I see that there are: one block which starts at 0:00, with no chance of modifying its start time one block which ends at 0:00, with no chance of modifying its end time one block which is in between and can be adjusted flexibly. Is it then possible to have 4 or more blocks in a day?
-
Confused don`t know what exactly I need
I live in a 3 bedroom 3 floors house, and I have a combi boiler installed. There is only 1 thermostat installed in ground floor, and 8 radiators all around. I want to install radiator thermostat on all radiators for this if I buy 8 radiator valves and the smart radiator thermostat starter kit V3+ is it enough or do i need…
-
Smart TRV operation
Hi all. Just had tado fitted thoughtout and seems when I call for heat in one room bed 1, I get heat in another room, bed 2. Even though bed 2 in set to off?? What does this mean? Thanks
-
tado° Wireless Temperature Sensor & Extension kit without Smart Thermometer
anyone using a tado° Wireless Temperature Sensor & Extension kit without the Smart Thermometer? i have a starter kit that came with the bridge and 2 x trv's. i have just ordered 8 x additional trv's & am hoping to save some money by purchasing the Wireless Temperature Sensor & Extension kit for ~£98 instead of the smart…
-
Installation question
Hi, I have a new build townhouse over 3 floors with a really poor central heating design. The house is split into 2 heating zones - downstairs I have the thermostat in the hallway and the thermostat is placed outside the kitchen on the otherside of the wall from the oven. This means the downstairs hall heats up very…
-
Smart thermostat and srv in same room?
Hay guys. So I have just had tado fitted thoughtout home. I have a smart thermostat and a smart TRV in the hall. What role do they both play and should they be grouped together. As don't see what happens when they are both set at different temps? Slightly confused. Thanks.
-
Best layout - thermostat and 3 TRVs
Hi there, I’ve had tado for a year or so with only the start thermostat. I bought a smart trv the other day and installed it in my bedroom and have just ordered two more (prime day!) and I’m wondering where to put them. Current setup: Upstairs: master bed - smart trv Master en-suite - dumb valves - towel rail Family bath:…
-
Switching from Hive - Boost question
Hi - we’re thinking of switching from a Hive single thermostat to a Tado multi room system. With Hive we can say “Alexa, boost heating” which will use a default of something like 22 degrees for an hour. More specifically we can say “Alexa set heating to 20 degrees for 30 minutes” after which it will drop back to whatever…
-
How to: Switch to away mode when my wife leaves house but leave my study heating on.
Hi everyone, I work from home. My wife is often out of the house while I am working. I only want to heat the rest of the house when my wife is in (or on the way back to the house). Is this how I would do this: (1) Subscribe to Auto Assist (2) In my "Study", under smart schedule (advanced settings within a time block) -…
-
Can i use a smart thermostat as a temperature sensor?
As we speak the Smart Thermostat has been reduced by 50% on Amazon Prime day here in the UK. The Wireless Temp Sensor is technically cheaper but it wont get delivered till Nov 20th! For an extra £10 you can get the fully blown Thermostat. Can you just use the smart thermostat as a wireless temp sensor instead?
-
One Smart Radiator Thermostat controlling radiators without SRT but on same network
We have radiators with smart thermostats and then radiators without them controlled by the main smart thermostat (the one with the pixel display) When the radiator thermostat in our study is turned up to heat that room more it makes the radiators without smart radiator thermostats heat up too. Should this be happening!?…
-
wireless temperature sensor in bathroom to control under floor heating?
My electric UFH has a thermostat in a cupboard next to the bathroom, and is controlled by a sensor probe under the tiled floor in the bathroom. I was wondering if I can use the wireless temperature sensor in the bathroom, maybe sat on the floor to control a second wired thermostat to control the underfloor heating as a…
-
Stop manual tempreture change
Hi, Can you please let me know, how can I stop my kids from changing the tempreture directly from the Thermostat? They keep plaing with it du to its atractive look :) any way to disable manual change of tempreture!! Thanks Fadi
-
Moving from Hive to Tado
Hi there, A friend recommended this community for advice on Tado. I am thinking about making the jump from Hive to Tado. I have a v1 Hive active heating system that is not working anywhere near as well as it should (unable to control thermostat from internet/app) and, as it is gen one, I have to buy a whole new system to…
-
Support
Hi guys, tado used to be so good with support. I can't seem to reach anyone on chat, my email form hasn't been responded to either. All I want to do is switch heating modes at some point but need support's assistance. What can I do?
-
Boost the system
Hi My current set up is a wireless Thermostat and one radiator thermostat. I would like to add additional TRV to my remaining radiators, however, before I do that I have a question:- Is it possible to boost the system as a whole (so all of the radiators at once) without having to click each radiator separately/adjust…
-
Multiple users on one account
Since registering multiple accounts do not work upon registering the bridge, I opted to send an invite for to add multiple users. Email has not been received neither in the inbox nor junk/spam box. How do I grant access to my household with multiple users?
-
Boiler start time.
Why does the boiler switch on at 5.50 when it is clearly marked to switch on at 7.30? Please help explain.
-
Internetbridge loses connection when I'm using a multicast application.
Everytime I use livewire to stream audio over my network to multiple receivers the internet bridge will lose it's connection. I believe this is a designflaw because no other (iot) devices in my network have issues when the mutlicast traffic is present. Is this issue known, and is it being worked on?
-
Open window notifications
Hi all. I've read that some users are getting open window notifications to their phone. I use Android and have V3+ and can't seem to see this option. Would be useful due to false triggers etc. I have paid for the upgrade for smart skills but doesn't seem to be in there. Additionally, it would be even more useful to be sent…
-
Offset option disappeared?
Has Tado removed the ability to offset the shown temperature with the latest updates?