-
worcester 28i junior combi boiler.
I have a Worcester combi boiler, tried wiring it in as per the diagram, the relay energises on the tado kit when testing, nothing happens on my boiler.. ive seen people refer to an ST9 connection but i dont have that.. Has anyone come across this?
-
Confused about devices
Hi, just starting out and find the products confusing. For hot water there is an extension kit and a wireless receiver. It seems only the former is opentherm compatable, the latter requires re-wiring (not a standard UK backplate)? Wireless thermostats and sensors have the same model number with interchangeable…
-
What adaptors do I need?
I'm trying to install tado but I can't seem to find the right adaptor. I use the danfoss adaptor (the thermostats are danfoss) but I keep getting error 2, because I think the pin is too far in. Have you had this situation? how did you solve it?
-
Zone control advise
Hi, I would like to gain zone control of my current setup. Prior to tado I could heat ground or first floor zones independently via a wired thermostat in each of these zones. So getting that again and independent control to heat just the bathroom too is my aim. My current system comprises of the following: Tado wireless…
-
Bathroom Underfloor Heating
Hi There, The last zone in the house is getting the tado treatment. This is a downstairs bathroom with wet UFH. The thermostat is outside in the corridor. Obviously, a wired 'stat is going to measure the temperature of the corridor and not the bathroom. If I use a sacrificial TRV, or even a wireless temp sensor, how can I…
-
Can I replace a 3 zone programmer and wired stat with wireless?
There is a bit more it than my initial question! I have a tricky system and not sure what hardware I need, so am hoping someone can help! I have a oil boiler that heats two buildings. I only want to ‘smart’ building 1. It is a Pressurised system with mega flow for the hot water. I have a three zone programmer that controls…
-
Installation of New Tado system with 15 Smart Radiator Thermostats
Dear Community, Have recently purchased a new amazing Tado system and have three installation questions. I am very keen for our new Tado system to maximise energy savings, utilise the full feature set, access reports to show others the savings we have achieved and ensuring the system is installed using “best practice”.…
-
Which Starter Kits/ Add-ons do I need?
Hi everyone, I have a new build with a two zone heating system (upstairs & downstairs). I currently have two Honeywell CM707 (wired) thermostats. Which kits would I need to replace both of these with Tado thermostats? Would I need two wired starter kits? or one wired and one add on? Thanks in advance! Ash
-
Not sure what I need!
I have a tricky system and not sure what hardware I need, so am hoping someone can help! I have a oil boiler that heats two buildings. I only want to ‘smart’ building 1. It is a Pressurised system with mega flow for the hot water. I have a three zone programmer that controls the rads, water, and the wet ufh in the main…
-
Tado installation
Hi sorry to Jump straight in with a question but im a bit confused, I already have installed 1 x wired Thermostat 1 x wireless temperature sensor 8 x smart radiator thermostats the installation is on a Baxi premium 600 boiler what im wanting to do is remove the wired thermostat and and install a wireless controller,I have…
-
Added New Radiator Thermostatic Valves
So, bought 3 new tado Smart Thermostatic heads to complete my system. My system is a Wireless V3+.....works okay. Installed the new valves in various places, 1 in the Kitchen is giving me grief. Not sure if I understand the tado synopsis which is the reason for this post.....tado documentation is woeful. The valve installs…
-
Add LG AC Remote AKB73757603 to Smart AC Control failed
Add LG AC Remote AKB73757603 to Smart AC Control failed. Message Update failed after Rec IR
-
Thermostat wiring help needed!
Hi all, I am about to replace this ancient Towerstat thermostat with my wired Tado. I don't have the stickers any more. Could someone tell me what the correct wiring is to the Tado please? TIA
-
Multiple Thermostats and extension opentherm connections
Simple question hopefully I have a set up where the customer would like boiler Modulation on a valiant boiler, They currently have it wired as 3 zones (up rads down rads and UFH) they have zone valves on each and the UFH has blend and pump (pump connected on the zone valve live off the tado stat) with a wireless extender…
-
Wireless underfloor heating control with non-thermostatic valves.
I have a wireless starter kit and thermostat all working with the boiler. We have underfloor heating around the whole home with 16 valves over two manafolds, one upstairs and one downstairs. Upstairs we are happy to keep as one zone, but downstairs we would like to split into at least three zones. I now understand the Tado…
-
Trying to get system with dumb and smart TRVs to play ball.
Hey, So I've had tado installed for a while, but I've ran into some problems that I can't seem to get my head around. I've got a few Smart TRV's in the most commonly used rooms, but I've not spent the extra to outfit the lesser-used rooms. I have the wireless thermostat with the relay box connected to the boiler. Also…
-
Adding Smart TRV into the mix of 2 Smart Thermostats and an Extension kit
Hello! I've not had much luck in terms of getting useful answers out of tado support, so hoping maybe I can get some better answers here. I've got an ideal Logic+ System S24 boiler. Today (because I looked at the installation and servicing booklet after it was services), I noticed it actually supports OpenTherm. My current…
-
Cant see the white writing on the orange back ground
Hi Ive just installed Tado all went reasonably well. But so far one problem is my wife has a hard time seeing white writing on coloured back ground. But she cant see the writing on the orange background. Obviously didnt give it a thought, but can the colour be changed or even changed to black and white??
-
Will Tado work for me?
I live in an old house (1580) with stone walls, some 2 feet thick. Wi-Fi is an issue, so I have six Access Points and a central controller. the central heating is provided by a Valliant plus ecoTec637 driving a mains pressure system, with a Horstmann Channelplus H37XL timer for two heating circuits and hot water. There are…
-
Wiring Advice
Evening and thanks for taking the time to read. Family members house has an oil boiler (no hot water) controller with an ancient analog time clock (this is all located outside in a shed). It has finally stopped working (time clock broken completely). As a replacement they are swapping the time clock control for a tado…
-
Setting up with Worcester Greenstar 28i Junior Combi mkV
I have my internet bridge, wireless temperature sensor and app working. If I decommission the old wireless sensor does the Tado temp sensor just take over? I’m assuming not, how do I sync it with the boiler?
-
Radiator valve not fitting
Hi all, I've tried all parts but nothing seems to fit. I’ve installed 4 other tado s with no issue so it’s quiet frustrating. any tips ?
-
Old radiator valve
hi all, ive tried all different set ups for this valve but nothing seems to work. any ideas how to fix this
-
SRT powers off when mounted
Hi all, I’ve fitted my tado system this morning and all seemed to be going well, but one of the rad values is playing up. It pairs no issue, but as soon as I go to mount it, the body appears to power off. It’s like pressure on the battery compartment turns it off. No response from the dial etc. I've tried swapping…
-
SORT IT OUT TADO!!!
Once again heating has shown it is off but come home to find the boiler fully fired up and heating rooms that are TRV controlled, app shows they are off!!! Either sort the software problem or get some kind of range extender as many are asking for!!!! What the point in having a remote system that doesn’t work remotely!!!…
-
Heat Pump remote monitoring
Can Tado remote monitor your Heat Pump.? Does it connect to a data bus connector and read sensor data etc?
-
Vaillant Green iQ Boiler Compatibility
We’ve had Tado for 5+ years - and it has worked well with our Worcester-Bosch combi boiler. But our boiler now needs replacing and we are going to buy a Vaillant ecoTEC exclusive with Green iQ combi 843. Wiill our Tado still be able to work with this new boiler? And/or should we upgrade to better control our separate (wet)…
-
Heating not functioning properly after bridge swapp
Hi, first time here (first time it’s all gone belly up!). I had a working system (for probably 4+ years), it consists of a normal boiler feeding a hot water cylinder, a 3 way valve being controlled by Tado extension kit ( the new one which was sent to me for Beta testing a year ago). I have 3 bedrooms and a living room and…
-
Zone Setup advice
Good Morning, I am looking for some advice on my setup and if the changes I am planning will actually work! Current Setup I have a single zone central heating system that has 1 x wired Smart Thermostat. Downstairs I do NOT have any Smart Radiator Valves attached to any of the downstairs radiators, just normal TRV's and I…
-
Will Tado work with my multi zone Worcest Bosch Combi Boiler set up, including EMS modulation?
I have a Worcester Bosch Greenstar CDi Compact 32, which I believe uses the EMS Bus language, so I've been looking for a Smart Thermostat that can properly modulate my combi boiler. I've heard the Tado can do EMS control. But since I have a multi zone set up (upstairs and downstairs zones), I'd like to confirm that it'd…