-
More than one setting for each room
I have two rooms for which I regularly change the settings. I would like to be able to have two alternative settings for each room so that I can switch between the two and not have to completely reset the room each time.
-
Add undo button to scheduler
It is very easy to make a mistake when designing the schedule which accidentally deletes all the changes you've previously spent time making. Please can you add an undo button to undo whatever you did last. This could go next to the copy paste buttons quite nicely.
-
.set all rooms at same time
Add a button that will reduce the temperature by 1 degrees at every press and another the minus 1 deg. So you can set your complete system up or down at a touch
-
Show energyIQ in GBP
Show consumption costs in GBP in energyIQ
-
Create limits for heating
To create a limit for the heating for when someone is staying over
-
Boost by 5° not up to 25°
I have my heating relatively low but if it dips a few degrees and I want to boost it I don’t want to boost to the maximum 25. 5° more than the current temp would be enough. In this age of trying to be energy efficient and a fuel crisis maxing out the temp is illogical
-
make geofencing free.
I was always surprised that geofencing needed a subscription. When receiving this email below. Geofencing has a much bigger impact. So make geofencing free. "Take action now to reduce energy consumption in a joint effort Hello Robert, Did you know that lowering your home temperature by 1°C will reduce energy consumption by…
-
Unify AC V3+ experience with the rest of the Tado products
Hi, I have multiple Tado products in my home - 5x RTV, 1x Thermostat, 1x Home Bridge, 1x AC controller. The experience across these devices is so different that the AC controller almost feels like it was made by a different company (it is not great). Would it be possible to enable pairing of the AC controller with the Tado…
-
Heat pump simulation mode
With ASHPs being pushed so aggressively in the U.K. and with Tado users likely being on the forefront of heating efficiency, it seems to me that a ‘simulation’ mode would be helpful. The idea would be that tado (when linked to digital connections) would cap the max water temp at 55 deg and ideally target lower temps. It…
-
zones
hi guys any chance of a feature that allows you to block rooms together. i.e. upstairs/downstairs/bedrooms. you could simply call them zones. if you can and the boost into this aswell so hitting "boost upstairs" would heat everything in your "upstairs" zone. tell me what you think, thanks
-
Set a maximum radiator temperature, to keep the boiler condensing efficiently.
Hi, Tado achieves a lot of its efficiency by modulating the boiler temperature. However, the variability in environmental temperature makes it very difficult to produce a room temperature profile that will not a some point be caught out, resulting in the boiler going to its maximum output temperature for a short period of…
-
Add WPA3 support to AC V3+ Controller
Hi, would it be possible to add support for WPA3 to the Smart AC V3+ controller? This security protocol is becoming the new standard, and right now, at least on my network, it is the only device that doesn't support this protocol. Cheers
-
Extra safety feature
For some reason my Tado heated up to 57c after a change of installation in the setup menu. Therefore I think a check/failsafe in the firmware of the Tado for when the temperature goes up to more then 30c in a short period it should turn itself of and give a notice in the app. It melted My Tado wired where you press to turn…