Wireless receiver wiring question - CH NC
gac
✭
Hello, I have tado up and running for the last 8 months on my old combi boiler, my boiler died and I have had a new make combi boiler installed.
I have selected the correct boiler for installation instructions, the brown, blue, grey, black get wired to wireless receiver and boiler panel, but in the set up instructions it is showing a wire, little dash lines CH NC, but I only have the 4 wires off the tado cable, no other thermostats in the house.
Any help would be very much appreciated
Many thanks
I have selected the correct boiler for installation instructions, the brown, blue, grey, black get wired to wireless receiver and boiler panel, but in the set up instructions it is showing a wire, little dash lines CH NC, but I only have the 4 wires off the tado cable, no other thermostats in the house.
Any help would be very much appreciated
Many thanks
Tagged:
0
Comments
-
@gac Hello gac. If this was a replacement boiler, the first port of call should be to your installer? If they can't help, reach out to Tado with your question. The main Tado website has a chat function on the lower-right of the page.
For the user community to help you, you'll need to provide more information: Make/model of boiler old/new. Do you use zone valves? The Tado equipment you are using. Relay ON/OFF or opentherm? Photo's (including your old/new wiring) are very helpful and are easiest loaded from a web-browser.
1
