Tado Wireless reciever as switch
Hi
Can the Tado Wireless reciever be used as a switch to simple switch on 230V to some equipment? What is the maxiumum current cunsumption?
The reason is that I have a single zone water based underfloor heating. Today there is just a wireless room temperature sensor and a reciever that switch 230V power on a pump and an actuator. Can that be replaced by a Tado wireless starter kit?
Comments
-
You can almost certainly use Tado for the set up but you'd need to know the current draw of the devices you'll be switching. As far as I know, the wireless receiver can switch 3 amps which is normally more than enough
Note that it's normal for the switching to manage the valve/actuator. That device then has an internal switch that turns on the boiler/pump. This is a protection mechanism so that a pump isn't started if the valve is stuck
1 -
Thank you very much for your answer. 3 amps should be more than enough :-)
0
