No remote access on all thermostats except one
I'm going through an installation, I have the bridge I've installed 8 valves.
All except one show no remote access. The one that works is not any nearer the bridge, nothing special about it, it just worked and was the last one I installed.
I've moved the bridge, no difference, tried to repair with the bridge on a couple of devices and no difference. I can get the device to say HI and otherwise looks like it's connected. I get alerts about windows being open from them even through no remote access.
Any ideas?
All except one show no remote access. The one that works is not any nearer the bridge, nothing special about it, it just worked and was the last one I installed.
I've moved the bridge, no difference, tried to repair with the bridge on a couple of devices and no difference. I can get the device to say HI and otherwise looks like it's connected. I get alerts about windows being open from them even through no remote access.
Any ideas?
0
Comments
-
Have you tried unmounting all the SRTs and placing them all near the bridge? If all the devices are within a metre of each other it will allow you to determine if distance is an issue, or a problem elsewhere.
0 -
Yes I've tried on a few, I've moved the bridge next to one, repaired, all looks connected but still says no remote access.0
-
You don’t refer to a room thermostat or wireless receiver. Do you have one of these acting as a zone controller to switch the heat source on/off?
0 -
That what the problem is I've just figured , the thermostat per room needed to be switched off as I've not yet got my full system working! Thanks for your help.0
