w.Intercom = i;Set temperature — tado° Community

Set temperature

kcharles11
kcharles11
edited June 2022 in General Questions & Topics

My tado is going over the set temperature

Answers

  • Stoneblade
    Stoneblade
    Just installed tado on a underfloor heating system and have found this too. I now have to set back the stat in the schedule to 1c to compensate for the over run. I have noticed that the 3 wiggly lines count down as it moves through the 1c after the set temperature which I thought would do it whilst going through the last 1c.

    Ie, I set the temp at 21c. Reaches 21c, wiggly lines goes to 2 instead of 3, then at 21.5c goes to 1 line,and then turns off at about 21.8c. Something isn't right here.

Categories