Underfloor heating temperature
Hi guys. I just installed my new tado for my underfloor heating. The problem is that it recognise the room‘s temperature and not the actual floor‘s.
so the situation is that the room is warm enough but the floor is cold....
i would like to install another one in the shower where the floor heating wired controller is next to a radiator, so there again, if i indtall tado wired controller, it will think that the room‘s temperature is high and ignore the floor‘s teperature..
is there a way to fix it? Otherwise i am not sure if i should change my whole underfloor heating system zones to tado....
looking forward to hear back,
thanx
0