w.Intercom = i;Advice on replacing a British Gas UT2 Programmer with the V3+ — tado° Community

Advice on replacing a British Gas UT2 Programmer with the V3+

RogueMonkey
RogueMonkey ✭
in General Questions & Topics

Hello Folks,

I've been doing some digging and looking for some advice on installing the V3+.

I've got a combi boiler (Worcester Junior 24i), programmer is just for switching heating on and off. Hot Water is on demand.

Could someone advise on the setup for the V3+?

I've a power switch that cuts/provides power to the programmer which then connects to the boiler.

2xLive, 2x Neutral, 2x earth, 1 yellow to (1), 1 black to (3), any idea how that translates to the V3+?

Can the doubles just be wired as they are and where do the single yellow and black wires go on the V3?

Any help would be greatly appreciated.

Cheers,

Gerry

20241211_090454.jpg

Answers

  • mindstorm
    mindstorm ✭✭

    As I see it, replicate this on the V3. Yellow is your CH COM and black is the CH NO (ON). Hopefully you can get the earths to the connection point on the V3.

    image.png

Categories