w.Intercom = i;New DIY install replacing TP9000 — tado° Community

New DIY install replacing TP9000

SammyR1982
SammyR1982 ✭
in General Questions & Topics

I have a viessmann system boiler and hot water tank controlled by a Danfoss TP9000 on the 1st floor landing which schedules the HW and CH. I'm looking to DIY install the Tado V3+ Wireless Heating & Hot Water Smart Thermostat Starter Kit. I'll replace the TP9000 (no remote sensors) with the wireless reciever which appears to be a straight swap, could it really be that simple? Any help much appreciated 🙂

20241031_102200~2.jpg
20241031_102312.jpg

Comments

  • policywonk
    policywonk ✭✭✭
    What specific model of boiler is it? It affects the model of kit to purchase as well as the wiring involved. Please also clarify whether there are zone valves involved and what specific thermstats control those valves.
  • SammyR1982
    SammyR1982 ✭
    edited November 1

    Boiler is a vitodens 100w, 2 motorised valves near hw tank, right one for radiator circuit and left to tank heat exchanger, photo attached. Hot Water tank has temperature thermostat, heating uses thermostat integral to the tp9000 programmer.

    20241101_184359~2.jpg
    20241101_184729~2.jpg

  • wateroakley
    wateroakley Volunteer Moderator

    @SammyR1982 Welcome. This looks like a straightforward swap to me. Best to reach out to the Tado support guys for confirmation from the main web site.

  • policywonk
    policywonk ✭✭✭
    Make sure they get the exact model of vitodens 100.

Categories