w.Intercom = i;Install Tado on Vailant EcoTech Plus 825 replace BDR91 — tado° Community

Install Tado on Vailant EcoTech Plus 825 replace BDR91

chapster
chapster
edited December 2023 in General Questions & Topics
Bdr91.jpg

Hi, Can anyone please comfirm i am correct , just to make sure.

I have a BDR91 and im replacing with the tado wireless reciever.

My existing wiring in BDR91 unit (attached)

  1. Am i correct, this is a "Potential Free" setup?
  2. Live(brown) from boiler AND power supply goto "L" in Tado reciever
  3. Neutral(blue) from boiler AND power supply goto "N" in Tado reciever
  4. Silver/grey wire from boiler goto "CH COM" in Tado reciever
  5. black wire from boiler goto "CH NO" in Tado reciever

I dont want a disaster on my hands, the wife will go nuts LOL

Comments

  • chapster
    chapster
    edited December 2023
    bdr91-wires.jpg

    Apparently im not allowed to take cover off the boiler even to look at the wiring on the board.

    P.S. the bare cables in BDR91 are not my handywork. This is the first time i have seen inside the box. The Pro Installer fitted this.

  • chapster
    chapster
    Answer ✓
    Ok , you live and learn. All done. I didn’t realise the instructions when setting up clearly show how to wire the receiver for the bdr91.
    At least I was forced to find out what “potential free” is. Don’t necessarily understand it, but I know what it is.
    But all good and tado system seems great so far.
  • George1987
    George1987
    What was the answer for this please? I have the same wireing on my old bdr91. do you do as you have said and put both live into the tado terminal? It is what I am assuming but can't find any info and the help centre are not being very quick

Categories