The instructions are very unclear on this one bit!
Ok so when connecting the wireless receiver to the boiler.
It says connect to terminal 1 and 2. Black and grey wires. It then proceeds to show just a picture of one grey wire attached to terminal 2 and one white wire which is never spoken about. Please help
It says connect to terminal 1 and 2. Black and grey wires. It then proceeds to show just a picture of one grey wire attached to terminal 2 and one white wire which is never spoken about. Please help
0
Comments
-
Prior to that it should show you a picture of which labels to put on your existing wires on your old receiver L, N, NC etc. Once you have done that you disconnect the old receiver and connect those labelled wires to the terminals corresponding to then on the receiver. Confused me too at first. If you don't have an existing receiver, I am not sure.
0
