w.Intercom = i;Installing Tado V3+ — tado° Community

Installing Tado V3+

bazeze
bazeze
edited November 2023 in General Questions & Topics

Hi

I am new to smart heating. currently i have Sunvic theremostart and would like to replace with Tado.

On Sunvic thermostat there are 4 cable neutral, live and other 2 cable black and grey.

20231106_163229.jpg
1000045947.jpg

My question is how do i Install Tado

Answers

  • johnnyp78
    johnnyp78 ✭✭✭
    Have you started the install? You should get instructions from Tado.
  • wateroakley
    wateroakley Volunteer Moderator

    These two channel thermostat/controllers usually have a standard backplate? 1. Neutral. 2. Live. 3. & 4. Not used. 5. HW ON. 6. CH ON. It should be a straightforward swap of the four wires to the connections on the wireless receiver of the wireless starter kit. You'll need to bridge the wires on your thermostat (what make/model are you using?) to 'call for heat' and add two links from Live to COM on the wireless receiver. The starter kit comes with the Wago and wire links. The internet dongle plugs into an ethernet port and usb power on your broadband router. When you install the devices, reach out to Tado and they will send you wiring instructions.

  • bazeze
    bazeze
    edited November 2023

    No, i havent start the install.

    V3 Thermostat.

    I am currently using Sunvic Select XL.

    boiler: Ideal Classic SE15 FF

    thanks

Categories