New installation- no CH when asking for heat the receiver trips off.

Options
John_R
John_R ✭
in General Questions & Topics
I’ve just installed a tado system m. Changed my old Danfoss controller for the s new receiver, all looks ok however when you ask for heat the receiver trips off then resets . I assume it’s. Wiring issue but nothing obvious

Answers

  • royi
    royi ✭✭
    Options

    This could be a quick fix. Could you provide images or explain your set up.

  • John_R
    John_R ✭
    Options
    See attached pictures, The original controller was a danfoss TS715-SI. When I press for heat the unit switches off. The tado unit is heat and water, I am only using the heat.
  • johnnyp78
    johnnyp78 ✭✭✭
    Options
    Did you get installation instructions from Tado? Otherwise might be worth redoing the wiring and making sure everything’s in the right place.
  • wateroakley
    wateroakley ✭✭✭
    edited October 2023
    Options

    Wires on both NC and NO looks odd. Not saying it’s wrong, just that the odd wiring is suspicious.

Categories