Initial Wireless receiver setup
TADO have told me my receiver is saying its connected to the relays on the boiler and not the digital - ive followed all their instructions and wired everything correctly.
Is there a way to reset the receiver so that it picks up the correct instructions because last week just to test out its wireless connection i plugged it in without it being connected to the boiler and this might have therefore defaulted to relay which hasnt been overidden to digital again.
Pic shows deffo linked from the EMS Bus part of the boiler to the digital here and the wires are in as requested
Best Answers
-
Have you checked it with the Tado Pro app? That or run through the config from the wireless thermostat.
0 -
ooooh there's a PRO app - ok have just looked through - the chaps at TADO have now configured it properly for an EMS bus and its working properly- interestingly its got hot water control activated even though its a combi boiler without a tank - does this need to left on or switched off or is it irrelevant?
0 -
You should have temperature control of the hot water. On some combis if you switch it off in the app, it reverts control to the boiler, on others it switches off the hot water so best to see what works for you.1
Answers
-
thanks for the reply - yes hot water temp seems to only be controlled by the dial on the front of the boiler no matter what i do but that’s fine as it’s just used for showering0