w.Intercom = i;Use wired smart thermostat to give EBUS connection to boiler then add wireless — tado° Community

Use wired smart thermostat to give EBUS connection to boiler then add wireless

MaxTheDog
MaxTheDog ✭
in General Questions & Topics

Can any advise if a wired smart thermostat can be used to give the boiler connection with EBUS and if additional wireless smart thermostats can be added so that a extension kit is not required?

Comments

  • johnnyp78
    johnnyp78 ✭✭✭
    Yes, if you have a combi and Tado supports your boiler’s version of ebus.
  • MaxTheDog
    MaxTheDog ✭

    Thanks for the response I have a vaillant boiler which is showing as being supported, I currently have it running on the V3+ kit with wireless extension and wireless smart thermostat and already showing a reduction in gas usage after just one day so was hoping to get a wired thermostat to essentially replace the wireless extension and keeping the wireless thermostat then take advantage on modulation of the boiler by the Tado.

    Would this be possible?

  • johnnyp78
    johnnyp78 ✭✭✭
    It should be. You’ll need to run + and - on the wired thermostat to the digital connections on your boiler. Park live and neutral. As you already have a Tado system installed you might need to configure it for ebus. Instructions below.


    https://cdn.brandfolder.io/607DGEMS/as/7k4rssnm8hbmr6mjf94qmck/104210-DIGITAL-ST01IB01-INSTALLER_MANUAL-TA-EN-00-V3.pdf
  • MaxTheDog
    MaxTheDog ✭

    johnnyp78

    Thanks for the update, I think this will be a project for the new year as just purchased the V3+ kit and radiator thermostats

Categories