Starter Kit + TRVs installed, no hot water
Set Up:
Y Plan, Worcester boiler (not combi, but fully pumped (expansion tank, not gravity fed)).
Wireless Thermostat in hall
8 Tado TRVs installed on 8 out of 9 radiators (one rad is normal and fully open in the hall)
CH working as expected, rooms on schedules, TRVs working fine, get happy.
However, HW is not working.
Install instructions for replacing the Honeywell control unit was perfect and straight forward.
The test button on the Wireless Receiver (that replaced the Honeywell timer unit) works for CH but not for HW. The white LEDs that are on seem to blink.
When the unit is in config mode (holding HW and CH down for 5 secs) the power light is yellow, indicating a combi boiler setting, not green for Y Plan. Try to save in Y plan setting and LEDs blink white.
As a backup I can use the immersion heater, but baffled as to why HW not working.
Can anyone help?
Comments
-
If it won’t save to Y plan mode then it seems like a problem with the device.0
-
@johnnyp78 thanks for the note, will be onto Tado support on Monday.
0 -
I have this case logged with Tado support, but if anyone can double check my setup before they reply next week, then that would be great. Maybe I am missing something.
Anyhow, have a look at the photos from the original timer unit and the Tado receiver etc and see if anything obvious jumps out.
Thanks everyone.
0 -
Hey, tado tech support identified the issue, did some remote wizardry on the receiver and all is now good.
0
