w.Intercom = i;What terminals for NTC sensor. — tado° Community

What terminals for NTC sensor.

Kornebaek
Kornebaek
in General Questions & Topics
Hi there.
Im about to connect my new wireless starterkit v3.
But i seem to have a 2 wire NTC temperature sensor that works on a ohm restiance..
What terminals shall i use on my wireless reciver?

Answers

  • johnnyp78
    johnnyp78 ✭✭✭
    You should get instructions from Tado through the app when you do the install.
  • Kornebaek
    Kornebaek
    Hi Johnnyp78
    There is no instructions for a NTC element 😕
  • GrilledCheese2
    GrilledCheese2 ✭✭✭
    edited November 2022

    Not sure if the sensor is for UFH or a hot water cylinder; unfortunately Tado does not support NTC sensors.

  • Kissarmy
    Kissarmy ✭✭
    I've seen room thermostats that advertise they use an NTC for temperature measurement but the output from the thermostat is still just a switch closure on/off.
    My boiler has several NTCs but they are just temp sensors on the flow and return pipes and the hot water feed but dont have anything to do with calling for heat from the boiler.
    It would be helpful to have some details of the make and model number of your boiler and thermostat.

Categories