w.Intercom = i;Install Query on a Wocester Greenstar 24I — tado° Community

Install Query on a Wocester Greenstar 24I

CarolMM
CarolMM
in General Questions & Topics

Hi all! I Have a Wocester Greenstar 24i Junior with a DT20RF controller. i am sorry if this is a really dumb question but how do I get into the current controller to wire in the Tado controller. There do not seem to be any obvious screws or pulls to get into it!!

Carol

image.png


Answers

  • johnnyp78
    johnnyp78 ✭✭✭
    Have a look at p29. If you’re not confident about the wiring I would recommend getting a professional in.

    https://www.worcester-bosch.co.uk/support/literature/download/release/8716115167/12651
  • CarolMM
    CarolMM

    Thank you, v helpful....not sure if I need plumber or an electrician!!!!

  • johnnyp78
    johnnyp78 ✭✭✭
    Either one should be able to do it, it’s a relatively simple installation.
  • wateroakley
    wateroakley Volunteer Moderator
    edited October 2022

    @CarolMM the optional programmers on these boilers do vary, We turned off the power, cut the thermostat cable (T+E wires) and connected two of the wires into the wireless controller (Common and NO). Then set the boiler timer to 24x7. Should be an easy job for a competent sparky.

  • CarolMM
    CarolMM

    Thanks all for your help and suggestions..... 2 plumberand an electrician later it is working!! ☺️

  • Emre26
    Emre26

    Hi, I have exact same setup with you. Greenstar 24i and DT20RF controller. I am thinking to buy the wireless starter kit and I have a dumb question :)

    Is it possible if you can send a photo of the boiler with your final Tado setup? Are we replacing the DT20F controller thing on the boiler with the Tado wireless receiver? I mean obviously they are not the same shape and size. So, I am confused where and how we will connect the Tado wireless receiver?

    Thanks,

    Emre

Categories