Would Tado connected to Junkers CG2200W BUS ever work?
Hi!
Are there any chances for tado software to support digitally the above mentioned boiler? The available relay mode is the least energy saving solution of all and not very environmentally friendly.
This is a modern boiler using hysteresis to control the flame, allowing to use it for the most of time at minimal available power to keep heating as efficient as possible. BOSCH EasyControl supports it and I really regret I have bought tado as the only feature that I’ve received above BOSCH was HomeKit support.
Switching the boiler on in relay mode requires a lot of energy (gas). These boilers have been designed to work non-stop with a minimal power. So it would be so nice if tado supported modern boiler’s most important feature.
I don’t even mention a hot water controll feature….
Are there any chances for tado software to support digitally the above mentioned boiler? The available relay mode is the least energy saving solution of all and not very environmentally friendly.
This is a modern boiler using hysteresis to control the flame, allowing to use it for the most of time at minimal available power to keep heating as efficient as possible. BOSCH EasyControl supports it and I really regret I have bought tado as the only feature that I’ve received above BOSCH was HomeKit support.
Switching the boiler on in relay mode requires a lot of energy (gas). These boilers have been designed to work non-stop with a minimal power. So it would be so nice if tado supported modern boiler’s most important feature.
I don’t even mention a hot water controll feature….
0