w.Intercom = i;Have 2 internet bridge on the same network? — tado° Community

Have 2 internet bridge on the same network?

MadsEjnar
MadsEjnar ✭
edited June 2022 in General Questions & Topics

Hey

I'm looking to buy a house where they have ground source heat pump system in building "A", that provide heat to building A and B.

The main building, aka the house, is building B. But the control to the heating system is in building A by the heat pump.

So what i wish to do, is to have a "Wireless Temperature Sensor" in every room in building B and have a internet bridge to talk to all the sensor. And i building A have all "Smart Radiator Thermostat" to control the heat in every room, but i will need another internet bridge in building A to talk to every Thermostat.

So will this be possible in anywhy? Or something else i can do?

Answers

  • Unknown
    Unknown
    This content has been removed.
  • MadsEjnar
    MadsEjnar ✭

    I have sent it to the support now aswell :)

  • Rob2
    Rob2 ✭✭✭

    You cannot have 2 bridges within the same account. It may be possible to have 2 bridges on 2 separate accounts, although people have reported that this does not work when they are connected to the same internet connection. I, however, think that that is highly unlikely and that it should just work.

    However, then you have a separate account for house A and house B, and the devices in house B will not be able to command for heat to be provided from house A unless you have a smart thermostat in house B controlling the heater via a wire. But that may already be present for the current setup.

    Unfortunately you cannot control two accounts from the same APP without logging in and out all the time... There is really a LOT that Tado can improve for installations like this.

  • MadsEjnar
    MadsEjnar ✭

    It's a really strange heating system in the house. But it will work great if you like to have the same temperature 24/7.

    But i will like to be able to controle it and have it cooler at night and when i'm not home.

    And have to go inside build A to change the temparature for any room in building B every time i want it cooler og hotter is annoying. So there for a sensor in building B and to controle the Thermostat in building A will be great. But sure that the internet bridge cannot talk to all in build A and B because they both have full bick wall inside and outside :/

  • Rob2
    Rob2 ✭✭✭

    Ok but the Tado system cannot do that. Unless you would be able to run a 2-wire connection between the houses, and connect a smart thermostat in house B to the heating in house A. When the systems are configured in ON/OFF mode you can parallel the smart thermostats in both houses and have the radiator thermostats further control the temperature in each room. Or when there is a controlled valve in the heating line from A to B you can set it up as a separate heating zone.

    Unfortunately there is no possibility at all in the Tado system to extend the range of a single system. No 2 bridges, no repeater, nothing.

Categories