w.Intercom = i;Overriding setting — tado° Community

Overriding setting

scottie98
scottie98
edited June 2022 in General Questions & Topics

Excuse me if this has been asked before but I couldn’t find it.

My heating is set to 20 until 10pm. I have found if, for example I want to bump up heating to 21 at 9.30, I would have thought it would revert back to set ( overnight) temp at 10 pm (ie 15deg).

However, if I bump it up, it stays at that new target temp, whereas I want this bump to be temporary only to next setting change.

I hope I have explained this and thanks in advance

Comments

  • Andreplusplus
    Andreplusplus Volunteer Moderator

    Hi @scottie98 . You can temporarily adjust the target temperature in two ways: in the app and by manually adjustment on th pe thermostat or smart radiator valves.

    If you change it in the app by sliding up/down, after an instant a pencil is shown. You can tap on the pencil and then there are three options: for a certain duration (move the slider), until the next automatic change (schema or leave/arrive home) or indefinite (until you change it again).

    The same options you have for manual adjustment on a tado device. In the app go to the settings, rooms&devices, select the room and “Manual adjustment on a tado device” or whatever it is called. Then you can select the setting you want.

Categories