Integrating separated Heatmiser UFH
Hi all,
I’ve read a few post in here that appear related but my setup seems to be a little unique.
I have Tado controlling my traditional combi boiler and Tado TRV’s on all radiators today. However I also have three independent Heatmiser UFH zones with their own Neostat V2’s. I bought the house with these zones installed and there doesn’t appear to be any common controllers/pumps/etc (in fact I upgraded each to the V2 Neostats and a hub to use HomeKit).
Right now I’m assuming that I can buy three wired temperature sensors that would allow me to replace the Neostat V2’s and integrate these into the Tado system (one of the UFH zones also has a radiator with Tado TRV).
Is this correct and/or a rational thing to do?
Many thanks!!
I’ve read a few post in here that appear related but my setup seems to be a little unique.
I have Tado controlling my traditional combi boiler and Tado TRV’s on all radiators today. However I also have three independent Heatmiser UFH zones with their own Neostat V2’s. I bought the house with these zones installed and there doesn’t appear to be any common controllers/pumps/etc (in fact I upgraded each to the V2 Neostats and a hub to use HomeKit).
Right now I’m assuming that I can buy three wired temperature sensors that would allow me to replace the Neostat V2’s and integrate these into the Tado system (one of the UFH zones also has a radiator with Tado TRV).
Is this correct and/or a rational thing to do?
Many thanks!!
0
Answers
-
Did you get anywhere with this?
0 -
-
-
@FreeHonestTruth I didn't get this working yet, I did buy one Wired Smart Thermostat which I intend to experiment with in terms of replacing the Neostat units but unsure yet if this will work, or if the underfloor thermometer can also be connected.
@JimH obviously your system has a central pump/setup.
0
