Dual Zone set up
Hi
Really not sure what I need to purchase to replace my following system.
Current set up:
Danfoss TP9000 in the cupboard with the hot water tan
Danfoss TP4000 in the lounge downstairs (which controls the lounge radiators only)
Danfoss TS2 (I presume a sensor) in the hallway
Boiler is an Ideal Logic Heat 15
Please can someone advise what I require to set up Tado?
Thank you 😊
Really not sure what I need to purchase to replace my following system.
Current set up:
Danfoss TP9000 in the cupboard with the hot water tan
Danfoss TP4000 in the lounge downstairs (which controls the lounge radiators only)
Danfoss TS2 (I presume a sensor) in the hallway
Boiler is an Ideal Logic Heat 15
Please can someone advise what I require to set up Tado?
Thank you 😊
0
Comments
-
Hi 😊
Can anyone help me with this question please?0 -
The TP9000 is a dual channel programmer with remote sensor TS2. You can replace this with the Wireless Receiver Starter Kit. The TS2 sensor in the hall is wired but you won’t need to use the old wires when the Tado sensor is installed. You can mount the new sensor in the same spot, or move it to your preferred location.
The standard TP4000 is a wired thermostat (do check it’s not the TP4000 RF). The replacement for this is the Add-on Wired Thermostat.
The starter kit comes with a bridge/hub that needs to be connected to your internet router. The bridge, wireless receiver and sensor in the hall must not be too far apart as they need to communicate wirelessly.
0
