w.Intercom = i;Tado wireless receiver — tado° Community

Tado wireless receiver

Hi
I just installed the tado wireless receiver and wireless temperature sensor and I did exactly as instructed when removing my Drayton receiver and thermostat but I have an issue

After turning all the power back on everything seemed fine receiver switched on and connected to bridge then as heating was about to kick in the receiver just switched off and now it's not switching on at all

Any ideas please?

Answers

  • It blew the 3amp fuse once the heating or hot water kicked in . Replaced fuse and now have power again but on my old receiver. Does this mean I wired the tado receiver incorrectly?
  • Most likely a mis-wire of the receiver. I suspect you have an erroneous neutral wire or your current system is setup for low voltage.