Best Of
-
Re: Support 2 point calibration for adjusting temperature offset (Temperature Guesstimate)
I’d even go further to suggest to allow user to customise an offset “curve”. In similar scenario, say 20° is the true ambiance temperature, no offset is needed. When heating is on, 22° of the TRV act…5 -
Multiple homes
I would like to see the ability to view multiple properties from one login, having multiple places to manage is not easy when you have to logout and login to view second homes6 -
Leave the valves opened in 1, 2 or 3 gears
Nowadays we can close the valve (OFF) or open it fully (25º), and the control is based only in the temperature that the valve is measuring. The thing is that in my area where it below 0º at night, th…7 -
Incident Detection > Show boiler OpenTherm values / failure codes
For OpenTherm connections system should pass over the boiler properties and failures I am occasionally getting 2: Low water pressure errors presented on my boiler LCD (which also means no hot water o…6 -
Make Opentherm boiler specific tweaks possible
Hi! I'm having an issue with opentherm using my boiler Enbra CD34H. After some troubleshooting I found out that issue is caused by Opentherm message ID 14 (Maximum relative modulation) being send too…6