Throughout the app temperatures are reported and set in units of whole degrees. It would be beneficial to increase the granularity of both reporting and setting to half degree increments.
I modified the title as this currently only affects rooms that have a Smart Radiator Thermostat as a leader.
I totally agree with this, I have also been asking for this for a long time, both for the radiator thermostats, and the room thermostat on the actual thermostats themselves, as opposed to via the App. Seems a bit odd you can't set 0.1C increments on both pieces of equipment and being a dot matrix display should be easy enough to reprogram to show the 0.1C increments.
The difference between 20C and 21C is massive, it can't be right to leave it at that for the radiator stats.
Please implement this.
I need this now.
The history report does show values with decimals but why cannot we set the offset, target and display the current temperature in the app with decimals too? It;s simply silly.
Probably because relying on the TRV's built-in sensor isn't a great idea as it gives fairly inaccurate readings (it is, after all, connected indirectly to the heat source). I understand the point of it maybe allowing you finer control of the heat, but I wouldn't be trusting the TRVs to give you accurate room temperature readouts.
Also, it would make it harder for Tado to flog their smart thermostats! ;)
There are several threads around with the same subject. It seems there is a need, nut the votes are in to many different threads. A fresh one with large support should be started. This really needs to ne implemented!
Because the Smart Radiator Thermostats measure so close to a radiator, adding further granularity makes no sense. It would not accurately represent the rooms temperature anymore than the current granularity.
If you want more granularity, you could opt to buy the Smart Temperature Sensor and this will increase granularity because it also make sense because you place this device in a better spot.
At the moment, this increased granularity for just Smart Radiator Thermostats is not high on the overall priority list and I do not see that changing any time soon.
The vast majority of manufacturers that make TRVs have implemented this 0.5C granularity. Tado is among the few that do not have this.
I'm considering changing the TRV s to different brands as my tado is connected to Home Assistant and I control most from it here.
Please Tado make at least 0.5 (or 0.1) degree settings possible from the app to the different TRVs
Technical team had confirmed to me that the heating will actually trigger only when the temperature difference is at least 0.5°C …and that’s fine as firing a boiler for every 0.1°C change is not best option.
If this is compromise between system performance vs boiler life, Tado° should at least work on a software unification for each device and operating system.
iOS app – 0.1°C accuracy (display & change | app ver. 6.6.3)
Wired thermostat – 1°C accuracy (change) and 0.1°C (display)
WebApp - 0.1°C accuracy (display & change)
Siri – 1°C (voice commands | iOS 14.7)
Home app - 0.5°C accuracy (display & change | iOS 14.7)
@GrayDav4276 I need to stick up for Tado° on this, only because the system must be efficient and same time can not drain your boiler's resource. To me this is compromise, and I am fine with it. If Tado° reacts to 0.1°C temperature change, your boiler will be firing up constantly. I used to have Honeywell products with tolerance 0.5°C, so why can't Tado° follow?
They just need to unify each device and operating system, so everyone is on the same page!
It looks like you're new here. If you want to get involved, click one of these buttons!